Blue Rhino 153300 owner manual Connect Engine/Post Assembly to Cap, Connect Gas Line to Engine

Page 10

Contact 1-800-762-1142 for assistance.

Do not return to place of purchase.

Step 8 – Connect Engine/Post Assembly to Cap

•Insert end of Post with (4) holes not threaded over Gas Line

•Line up Post holes with threaded Cap holes.

•Loosely Secure Post to Cap, using (4) Medium Screws, fully tighten screws in Step 9.

Step 9 – Connect Gas Line to Engine

•To attach Gas Line to Control Valve:

•Pull collar of Gas Line down.

•Insert Gas Line over Control Valve.

•Release Gas Line Collar and it should lock in place. (Tip – push Gas Line up from bottom of Post to make a good seating before

releasing Collar.)

•Gently tug on line to test for proper connection. If Gas Line moves you are not properly connected.Do not proceed until a proper connection has been made.

•After gas line is secure, fully tighten (4) screws from Step 8.

9

Owner’s manual and assembly instructions: model 153300 outdoor patio heater

3/28/03

Image 10

Contents Manual del Usuario For Outdoor Use Only outside any enclosure 28/03 Safety First For Your Safety 20 lb. LP CylinderPicture Qty Additional Requirements General Components & Features Attach Legs to Base Attach Cylinder Shroud to Legs Attach Cap Assembly to Legs/Insert Gas LineAssemble Cup, Plate & Ring to Cap Assemble Emitter Assemble Emitter TopAttach Engine to Post Connect Engine/Post Assembly to Cap Connect Gas Line to EngineSecure Gas Line Attach Dome to EmitterConnect Gas Line to Cylinder Check for Leaks Check Gas Line / Cylinder valve for leaksInstall Cylinder Access Panel Replace Engine Access PanelBefore Lighting OperationBefore Turning Gas Supply on LightingRe-lighting When heater is onShut Down Before Operating After OperationIf the problem is This condition exists Then do this Maintenance During periods of extended inactivity or when transporting ServiceBetween uses Warranty Period Rating Safety FeaturesCertifications Heat RangeAdvertencia Índice ¡La Seguridad, lo Primero Pour Votre SécuritéBouteille de gaz de 9 kg Componentes FerreteríaRequisitos Adicionales Componentes Generales y CaracterísticasPaso 1 Acoplar las patas a la base Paso 2 Acoplar la protección de la bombona a las patas Paso 3 Montar la copa, la placa y el anillo en la cubiertaPaso 6 Montar el emisor Paso 5 Montar la cubierta del emisorPaso 7 Acoplar el motor al poste Paso 8 Conectar el conjunto motor/poste a la cubierta Paso 9 Conectar la línea de gas al motorPaso 11 Asegurar la línea de gas Paso 10 Acoplar la cúpula al emisorPaso 12 Conectar la línea de gas a la bombona Paso 13 Comprobar si hay fugas Compruebe si hay fugas en la línea de gas/bombonaPaso 14 Montar el panel de acceso a la bombona Paso 15 Volver a colocar el panel de acceso al motorAntes de activar la alimentación de gas on OperaciónAntes del encendido Reencendido Cuando el calentador está encendido onApagado Antes de la puesta en marcha Tras su funcionamientoAcumulación de carbonilla Advertencia MantenimientoEntre uso y uso ServicioDurante períodos largos de inactividad o para su transporte Período de Garantía Alcance calorífico CertificacionesConsumo CombustibleNASDAQ-RINO