LightSpeed Technologies X12, Delta X10 manual Replacing the Batteries

Page 26

LightSPEED

Operating Instructions

Wireless Transmitter

Belt-pack

CH: 001

2 Gain Adjust

720.250M

1

GT MT

CH: 001

LightSPEED3

GT

MT

Alkaline

4

NiMH

Nickel Metal Hydride

Rechargable

1.Transmitter Mute: The MUTE switch turns the transmitter’s audio signal on or off. The audio is off when the red LED is flashing.

2.Gain Adjust: When changing microphones or users, it may be necessary to adjust the transmitter gain based on differing microphone sensitivities and voice levels.

•To adjust the microphone gain, turn the MT dial clockwise to increase the gain and counterclockwise to decrease the gain.

•If you are using a high impedence source, such as a guitar, it will be necessary to adjust the GT dial. Using a high impedance source requires a special cable. Contact LightSPEED Technologies for more information.

3.Battery Life Indicator: The battery life is shown on the primary screen of the LCD. The 7-step fuel gauge acts as a detailed guide to show the actual life of the battery.

4.Battery Type: The transmitter will operate with either standard Alkaline Batteries or Nickel Metal Hydride (NiMH) Rechargable Batteries. Since these types of batteries have different characteristics, it is important to set the transmitter to the appropriate type of battery being used so that the battery life indicator will operate properly.

NOTE: Do not mix battery types.

WARNING: Do not use NiCad batteries! They will not charge properly and may cause damage to the transmitter.

5. To Change the Battery Type Setting:

•Press the “UP” button twice to get to the battery type screen.

•Press and hold the “SET” button until a blinking cursor appears.

•Use the UP and DOWN buttons to make a selection.

•Press and hold the “SET” button again until the blinking cursor disappears.

6.Replacing the Batteries:

•Open the plastic door by depressing the latches on each side.

•Insert two AA batteries and snap the door closed. Note the polarity in the battery compartment.

Typical battery life is about 8 hours.

Battery

Compartment

NiMH

AKLN

5

UP

Button

Set

Button

 

GT

 

MT

6

Door

 

Latch

 

DOWN

 

Button

LightSPEED Technologies • Wireless Sound Solutions • Toll Free: 1-800-840-3662

24

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Page Table of Contents System Overview DeltaSystem Controls and Functions DeltaSystem Base Unit LightSPEEDWireless Receivers 7100R Wireless Receiver Controls and FunctionsWireless Transmitter HM-900 Handheld Microphone Controls and FunctionsBelt-pack BP-900 BELT-PACK Transmitter Controls and FunctionsCD Player CD Player Controls and FunctionsPower/Charging Charging the BatteryMounting the Delta Speaker StandtripodSpeaker Stand Tripod Speaker/System Placement Speaker PlacementOperating Instructions Wireless Microphones DeltaWired Microphone Wired Microphone OperationCD Player Operation LOW +Connecting to Another Delta X10 or Delta Active Link OperationConnecting External Speakers Connecting External SpeakersExternal Audio IN/OUT Connecting External Audio SourcesConnecting Audio Output to External Devices Channel Selection Wireless Receiver Detailed Operation Wireless ReceiverPower up the Delta X system and wireless receivers Manual Channel Selection Transmission Frequency in MHz Press the UP Lock FunctionTo Change the Battery Type Setting Battery Life IndicatorBattery Type Sensitivity LevelCharger Status LED Channel Selection Belt-pack Transmitter Replacing the Batteries Charging the Batteries NiMH Rechargeable Batteries only Lapel MicrophonePlaying a Compact Disc Repeating00P Programming a PlaylistTrouble Shooting Guide No sound when someone speaks into the wireless microphoneSystem Specifications Delta X10/12 Base UnitChannel/Frequency Assignments Components & AccessoriesComponents & Accessories Component Serial Number WarrantyEquipment Log Purchase InformationUser Notes
Top Page Image Contents