LightSPEED
Operating Instructions
Wireless Transmitter
Belt-pack
Charging the Batteries (NiMH Rechargeable Batteries ONLY):
Make sure there are NiMH Rechargeable Batteries in the transmitter before plugging in the charger.
WARNING: Do not attempt to charge alkaline batteries. They can overheat and expand, creating a significant hazard and damaging the transmitter. (This is not covered by warranty.)
Charger Status LED
•RED = charging in progress
•GREEN = batteries fully charged 
Transmitter
Charger
Charger
Connector
LightSPEED
•Switch the transmitter power off.
•Insert the small DC plug into the jack on the side of the transmitter labeled “CHG”.
•Plug the other end of the charger into any standard 110 VAC outlet.
•The Red LED on the charger will light indicating charge is in process.
•When the batteries are fully charged, the light on the charger will turn green. A full charge can take up to 8 hours.
CONNECTING THE MICROPHONE
LightSPEED offers various types of microphones that can be used with this system. To connect the microphone, simply insert the microphone connector into the TA4F
connector on top of the transmitter. To remove, press the black button on theMic IN microphone connector and pull out.
MICROPHONE OPTIONS
The
Lapel Microphone
Several varieties of lapel microphones are available (pictured is the Audio Technica 831). Simply connect the microphone cord directly into the jack on top of the transmitter and clip the microphone to lapel or collar. For optimal sound, position the microphone as close to the mouth as possible.
Headset Microphone Several varieties of headset microphones are available (pictured is the LightSPEED
LightSPEED Technologies • Wireless Sound Solutions • Toll Free: | 25 |