Arrow Plastic CL72-A owner manual Anchoring Down The Building

Page 10

Anchoring

A10

Anchoring Down The Building

It is important that the entire floor frame be anchored after the building is erected.

Below are recommended ways of anchoring.

Arrow Anchoring Kit: (Model No. AK4 or 60298) Recommended for use with any suggested base. Contains: 4 Anchors with Cable, Clamps and installation instruction.

OVER THE BEAMS

AND INTO THE GROUND

Arrow Anchoring Kit: (Model No. AK100 or 68383) Recommended for use with the concrete foundation. Contains: Corner gussets, perimeter clips, hardware, 1/4" masonary drill bit and installation instruction.

Anchoring into Wood/Post:

Use 1/4" Wood Screws. There are 1/4" (0,63cm) dia. holes provided in the frames for proper anchoring.

1.2.

Anchoring into Concrete:

1.For poured concrete slab or footing or patio blocks: Use 1/4" x 2" Lag Screws.

2.For Anchor Post of Concrete poured after building is erected: Use 1/4" x 6" Lag Screws.

1.2.

10

Image 10
Contents Model No. CL72-A Before YOU Begin Plan Ahead Required Eye Goggles No Phillips ScrewdriverSafety First Care & Maintenance Other TipsAccessories Anchor KITThis WAS Left Blank Intentionally This WAS Left Blank Intentionally Foundation Foundation For Your BuildingAnchoring Anchoring Down The BuildingHardware Parts List Assembly by Key No Door Header Assembly StepDoor Assembly Sharp EdgeFloor Frame Assembly Corners/Side Angles 1Position right & left front cornerFrames Wall Panels/Rear Header Gables/Roof Rafters Door Jambs Roof Panel/Trim 4Attach the right & left roof trim toShelving/Mid Frame/Track 4Fasten the track tool holder acrossDoor Installation CL72-A