Step 4 | ● Parts Needed For ● |
Corners/Side Angles | |
BK17 |
|
●9432 Side Wall Angle (two)
●9446 Right Front Corner Panel (one)
●9447 Left Front Corner Panel (one)
●9444 Rear Corner Panel (two)
NOTE
The remainder of the building assembly requires many hours. Do not continue beyond this point if you do not have enough time to complete the assembly today. A partially assembled building can be severely damaged by light winds.
Each screw and bolt in the wall re- quires a washer.
1Position right & left front corner
panels at the corners of the floor frame as shown. The widest part of each corner panel must be placed along the front of the building. Fasten the corner panels to the floor frame with three screws, where shown.
Support the corner panel with a step ladder until overlap is fastened.
2Attach the rear corner panels to
the rear corners, as shown. The crimped rib should go under the rib of the adjacent panel. Fasten overlap- ping rib using 2 screws and a bolt with nut.
NOTE
Be careful to install the correct panel in each position as shown
3Fasten the side wall angles across the top of the side panels using screws.
the corner wall panels, before pro- ceeding.
The floor frame must be square and level or holes will not align.
STEP | 9444 | 9444 | |
| REAR | ||
|
|
| |
2
SIDE | TOP VIEW | SIDE |
Narrow
Side
Wide Side |
|
|
9447 | FRONT | 9446 |
STEP
1
STEP |
|
| Washer | |
4 | 9432 | Crimper Rib |
| STEP |
| Underneath |
| ||
|
| 9432 | 3 | |
|
|
| ||
|
|
|
| |
|
|
|
| |
Keepholesalignedaround building, towards the top
9444 | 9444 |
|
9447
9446
Panels rest onScrew frame as shown
17