Arrow Plastic CL72-A owner manual Step, Door Header Assembly

Page 14

Step 1	● Parts Needed For ●
Step 1	Door Header Assembly
BJ14

●9440 Door Header (one)

●9442 Starter Strip (one)

The door header reinforces the front wall and roof. It is made up of two pieces.

1Positioning the door header as shown, attach a starter strip to head- er using four screws, where shown.

9442

9440

Screw

STEP

1

14

Image 14

Contents Model No. CL72-A Before YOU Begin Plan Ahead Required Eye Goggles No Phillips ScrewdriverSafety First Care & Maintenance Other TipsAccessories Anchor KITThis WAS Left Blank Intentionally This WAS Left Blank Intentionally Foundation Foundation For Your BuildingAnchoring Anchoring Down The BuildingHardware Parts List Assembly by Key No Door Header Assembly StepDoor Assembly Sharp EdgeFloor Frame Assembly Corners/Side Angles 1Position right & left front cornerFrames Wall Panels/Rear Header Gables/Roof Rafters Door Jambs Roof Panel/Trim 4Attach the right & left roof trim toShelving/Mid Frame/Track 4Fasten the track tool holder acrossDoor Installation CL72-A