Arrow Plastic CL72-A owner manual Floor Frame Assembly

Page 16

	Step 3	● Parts Needed For ●	● 8984 Side Floor Frame (two)
		Floor Frame Assembly	● 9429 Ramp (one)
		Floor Frame Assembly	● 9430 Front/Rear Floor Frame (two)
	BJ16

The floor frame at the front of building is made up of two pieces. Proceed as follows:

1Center the ramp on top of the front floor frame. Join the frames by in- serting four screws.

2Place the floor frames on the foun-

Level

dation. Assemble the four corners of the floor frame using two screws at each corner as shown.

3Measure the floor frame diagonally. When the diagonal measurements are equal, the floor frame is square.

NOTE

Do not fasten the floor frame to your foundation at this time. You will anchor the building after it is erected.

STEP

1

STEP

2

8984

9430

9430

8984

9430

9429

Screw

8984

The floor frame must be square and level or holes will not align.

WhenDiagonalMeasurementsare

Equal the Floor Frame is Square.

STEP

3

16

Image 16

Contents Model No. CL72-A Before YOU Begin Plan Ahead Required Eye Goggles No Phillips ScrewdriverSafety First Care & Maintenance Other TipsAccessories Anchor KITThis WAS Left Blank Intentionally This WAS Left Blank Intentionally Foundation Foundation For Your BuildingAnchoring Anchoring Down The BuildingHardware Parts List Assembly by Key No Door Header Assembly StepDoor Assembly Sharp EdgeFloor Frame Assembly Corners/Side Angles 1Position right & left front cornerFrames Wall Panels/Rear Header Gables/Roof Rafters Door Jambs Roof Panel/Trim 4Attach the right & left roof trim toShelving/Mid Frame/Track 4Fasten the track tool holder acrossDoor Installation CL72-A