Z-1200II Operation
♦Add fluid carefully to the liquid tank. Do not overfill the tank.
♦Plug the remote control cord into the slot marked remote control on the back of the machine.
♦Plug power cord into a grounded electrical outlet. Turn the power switch to “ON” on the back of the machine. The red light on the remote will turn ON once the machine is plugged into a power outlet and the ON/OFF switch is turn ON. The unit will take a couple of minutes to warm up the heater. During this time the machine cannot generate fog. The green light on the remote will turn ON once the machine is ready to produce fog.
♦To emit fog press the green button on the remote.
♦For detailed instruction on the various functions on operating your
Important: Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can permanently damage the unit.
Z-1200II Description
Note: A fluid level sensor is installed on the unit. The machine will stop to fog if the fluid is lower than usable level.
If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the external fuse, remote control connection and power from the wall. If all of the above appears to be O.K., plug the unit again. If fog does not come out after holding the remote button down for 30 seconds, check the hose attached to the tank to make sure there is fluid going through the hose. If you are unable to
4