Z-1500II & Z-3000II Operation
♦Add fluid carefully to the liquid tank. Do not overfill the tank.
♦The Plug should be in a position that is accessible when using the machine.
♦Plug power cord into a grounded electrical outlet. Turn the power switch to “ON” on the back of the machine.
♦To emit fog press the appropriate button on the control module for the desired length of time.
♦The control unit display will display “Warming up” and “Ready to fog” as the machine
♦For further information on operating your
CAUTION: “Visibility during operation is reduced”.
This model can be operated at a floor level or sitting on any regular surface. Whatever installation method you choose, do not allow the unit to have more than 25 degree angle of inclination.
Important: Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can permanently damage the unit.
Note: A fluid level sensor is installed on the unit. The machine will stop to fog if the fluid is lower than usable level.
If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the external fuse, remote control connection and power from the wall. If all of the above appears to be O.K., plug the unit again. If fog does not come out after holding the remote button down for 30 seconds, check the hose attached to the tank to make sure there is fluid going through the hose. If you are unable to determine the cause of the problem, do not simply continue pushing the remote button, as this may damage the unit. Return the machine to your ANTARI dealer.
Technical Specifications
Model |
| ||
Power Supply |
| 115/230 | V AC 50/60 Hz~ |
Power Consumption | 1500 W |
| 3000 W |
Output Volume | 700 m³/min. |
| 1400 m³/min. |
Tank Capacity | 6 liters |
| 6 liters |
Fluid Consumption | 12 min./ liter |
| 6 min./ liter |
Weight | 14 kg |
| 20 kg |
Dimensions(LxWxH) | 688 x 285 x 188 mm |
| 735 x 310 x 192 mm |
Remote Included |
| ||
Optional Remote |
| ||
11 min. |
| 12 min. |
6