Gate/Slice Valves

The use of gate valves is recommended on all plumb- ing lines (both suction and return lines). These valves are used to contain the spa’s water in either the equip- ment or the spa. This will assist in the pump priming process and future servicing without needing to drain the spa.

NOTE: When draining the spa to perform mainte- nance, always close the gate valves prior to draining. This will maintain the pumps prime.

Connecting Plumbing to Remote Equipment

Connecting the plumbing from the spa to the equip- ment pack must be performed in accordance to local and city codes.

NOTE: Most codes require plumbing to be rigid PVC schedule 40 or heavier in both above and below ground installations. In most cases, the use of flexible PVC plumbing is acceptable when properly buried in trenches.

Most water plumbing lines are 2” or larger and must be schedule 40 or heavier PVC. When plumbing, mini- mize the use of 90˚ elbows as much as possible. The use of 45˚ elbows will increase the amount of jet pres- sure you will have over the use of 90˚ elbows.

Inground Spas

The plumbing on the spa shell is labeled by the factory in the following manner:

Pump 1 Suction: 2” line that connects the spa filter and bottom drain assembly to the front of pump 1.

Pump 1 Return: 2” line that connects the top of pump 1, through the equipment filter and heater back to selected jets in the spa.

Pump 2 Suction: 2” line that connects the spa filter and bottom drain assembly to the front of pump 2.

Pump 2 Return: 2” line that connects the top of pump 2 back to selected jets in the spa.

Ozone Line: 1” line that connects to a 1” flexible line extending off the bottom of the equipment pack filter canister through an ozone injector (If ozone equipped) and connected to ozone port on the spa.

Air Blower: 1 1/2” line that is plumbed out of the air blower (located on the equipment pack) and extended up 18” above the spas water level to prevent water flooding the air blower.

Air Venturi: 1/2” line that is plumbed 18” above the spa’s water level.

Topside Control Panel and Temp Sensor: 1” line that connects to the bottom of the control box located on the equipment pack.

19 Preparingfor

Your New Inground Spa

LTR20121002, Rev. A