Cal Spas LTR20121002 Diagnostic Messages, Message Meaning Action Required No message, On display

Page 27

Diagnostic Messages

Message

Meaning

Action Required

 

 

 

No message

1) Spa temperature is unknown.

1) After pump has been running for 2 minutes tempera-

on display

 

ture will be displayed.

 

2) Spa is in Economy or Sleep

2) In Economy or Sleep mode, the pump may be off for

 

mode.

hours outside a filter cycle. If you wish to see the cur-

 

 

rent spa temperature, either switch to Standard mode

 

 

or turn Jets1 on for at least two minutes.

 

3) Power has been cut off to the

3) The control panel will be disabled until power re-

 

spa.

turns. Spa settings and time of day will be preserved for

 

 

30 days with a battery back-up.

 

 

 

BUF

Internal problem detected.

Repair required. Contact your dealer or service organi-

 

 

zation.

 

 

 

dr

Insufficient water detected in

Check water level in spa. Refill if necessary. Make sure

 

heater. Spa will be shut down for

pumps are been primed and filter cartridges are clean.

 

15 minutes.

Press any button to reset or wait 15 minutes and spa

 

 

will automatically reset. If message spa does not reset,

 

 

call your dealer or service organization.

 

 

 

dry

Insufficient water detected in

Follow directions for dr message and press any button

dY

heater. Spa is shut down.

to reset spa. Spa will not automatically reset when dry

 

(Displays on third occurrence of

or dY is displayed.

 

 

 

dr message.)

 

 

 

 

Ec

Indicates heater is in Economy

None.

 

Mode.

 

 

 

 

--F or --C

Temperature unknown

After the pump has been running for two minutes, the

 

 

temperature will be displayed.

HL

A difference in readings between

Make sure spa is filled to proper level and that pumps

HFL

temperature sensors has been

are primed and filter cartridges are clean. If message

 

detected indicating a possible

does not reset, call your dealer or service organization.

 

water flow problem.

 

 

 

 

IC

Potential freeze condition de-

No action required. The pumps and the blower will au-

ICE

tected.

tomatically activate regardless of spa status.

 

 

 

LF

Persistent low flow problems.

Follow action required for HL or HFL message. Heating

 

Heater is shut down, but other

capacity of the spa will not reset automatically. Press

 

spa functions continue to run

any button to reset.

 

normally. Displays on the fifth

 

 

occurrence of the HL or HFL mes-

 

 

sage within 24 hours.

 

OH

Overheat protection. The spa has

DO NOT ENTER THE WATER. Remove the spa cover and

OHS

shut down. One of the sensors

allow water to cool. At 107°F, the spa should automati-

 

has detected that the spa water

cally reset. If spa does not reset, shut off the power to

 

is 110°F.

the spa and call your dealer or service organization.

 

 

 

Inground Spas

27 OperatingYour

Spa

LTR20121002, Rev. A

www.calspas.com

Image 27
Contents LTR20121002, Rev. a 12/30/11 Clear Water Plan Cleaning and MaintenanceDiverter Knobs Inground Spa Installation Checklist Preparing for Your New Inground SpaHyperthermia Danger Important Safety InstructionsInground Spa Installation Checklist Preparing for Your New Inground SpaPlanning the Best Location For Your Spa Site Excavation Hard Bottom Planning the Best Place for the Outdoor Equipment PackInground Spa Site Preparation Grading Prior to ExcavationIG-401 Spa Shell Dimensions and Side ViewsIG-402 IG-403 IG-404 IG-405 IG-406 IG-407 Electrical Requirements US and Canada Gfci and Wiring RequirementsTesting the Gfci Breaker Spa Model Gfci Required Wires RequiredGfci Wiring Diagram Electrical Installation -- Europe RCD and Wiring RequirementsTesting the RCD Breaker ForPreparing RCD Wiring DiagramInstalling the Inground Shell Plumbing Connections Equipment Pack Plumbing ConnectionsGate/Slice Valves Connecting Plumbing to Remote EquipmentRemote Equipment Topside Control Panel Electrical and Electronic ConnectionSee figure below Inground Spa Light Installation In- structionsPreparing forYour New Inground Spa Pouring the Deck Electronic Control Operation Light Setting the Temperature LockPreset Filter Cycles Clean-up CycleRCL Periodic Reminder MessagesMessage Frequency Action Required RPH RSADry Diagnostic MessagesMessage Meaning Action Required No message On displayMessage Meaning Action Required Snb SnsStby Diverter Knobs Adjustable JetsContents of this section Clear Water PlanKey to Clear Water Recommended total alkalinity is 80 120 ppm Testing and Adjusting Spa WaterBalancing the Total Alkalinity Balancing the pHUsing Chlorine as a Sanitizer Using Bromine as a SanitizerSanitation Filter Cleaning Chemical SafetyShocking the Water Starting the Spa with Fresh Water Bather LoadMaintenance Schedule Cleaning and Maintenance Removing and Reseating the PillowsSpa Cover Cleaning and Replacing the Filter Draining Your SpaWinterizing Cold Climate Draining Cleaning Your Spa Spa Cover and PillowsSpa Shell Replacement Parts WarrantyAppendix LTR20121002, Rev. a 12/30/11