Specifications
Specifications
Model Numbers
Serial Nos: 850,000 and Higher
QST20BE422; QST22BE482; QST24BE522; QST22BE482C; QST24BE522C
Systems
engine. (It is not necessary for the operator to be in the seat to start the engine.)
Engine
•Engine Specifications: See your Engine Owner’s Manual
•RPM:
–20HP
Full Speed: 3300 ±100 (max) RPM (No Load)
Idle: 1650 (min) RPM
–22HP & 24HP
Full Speed: 3650 ±100 (max) RPM (No Load)
Idle: 1650 (min) RPM
Fuel System
•Capacity: 4.0 gal. (15.1 L)
•Type of Fuel: Regular unleaded gasoline, 87 octane or higher; containing no more than 10% methanol or ethanol.
•Fuel Filter:
Briggs & Stratton P/N 695666
•Fuel
Electrical System
•Charging System: Flywheel Alternator
•Charging Capacity: 16 amps
•Battery Type: BCI Group U1
•Battery Voltage: 12 Volt
•Polarity: Negative Ground
•Fuses: One 25 amp, one 20 amp; one 15 amp blade type
•Diode: TVS
Safety Interlock System
•PTO must be disengaged, brake engaged, and motion control levers out (neutral lock) to start
•Operator must be in seat when PTO is engaged, brake is disengaged, or motion control levers are moved in or engine will stop.
•Engine will stop if either the left, the right, or both levers are moved from neutral lock position while brake is engaged.
Operator Controls
•Steering and Motion Control:
Note: Motion control levers are adjustable to two heights.
–Separate levers, on each side of the console, control speed and direction of travel of the respective drive wheels.
–Steering is controlled by varying the position of the levers relative to each other.
–Moving motion control levers outward (in slots) locks the drive system in neutral.
•PTO Engagement Switch: Engages electric clutch (to drive belt) which engages mower blades.
•Parking Brake Lever: Engages parking brake.
•Deck Height Adjustment Pin: Sets cutting height to desired position.
•Deck Lift Assist Lever: Foot pedal that assists in raising the deck.
Seat
•Type: Standard seat with high back, foam padded with spring suspension and armrests (armrests are optional on the 42 inch unit).
•Mounting: Hinged to tilt up for access to hydraulic pumps, battery and other components. Held in tilted position with lanyard. Adjustable fore and aft.
14