Exmark Lazer HP manual There is no rollover protection when the roll bar is down

Page 11

WARNING

POTENTIAL HAZARD

There is no rollover protection when the roll bar is down.

WHAT CAN HAPPEN

Wheels dropping over edges, ditches, steep banks, or water can cause rollovers, which may result in serious injury, death or drowning.

HOW TO AVOID THE HAZARD

Keep the roll bar in the raised and locked position and use seat belt.

Lower the roll bar only when absolutely necessary.

Do not wear seat belt when the roll bar is down.

Drive slowly and carefully.

Raise the roll bar as soon as clearance permits.

Be certain that the seat belt can be released quickly if the machine is driven or rolls into ponds of water.

Check carefully for overhead clearances (i.e. branches, doorways, and electrical wires) before driving under any objects and do not contact them.

1.4.6Use EXTREME caution when backing up. LOOK BEHIND YOU!

1.4.7Stop the blades when crossing surfaces other than grass and when transporting the mower to and from the area to be mowed.

1.4.8Never operate the mower with damaged guards, shields, or covers. Always have safety shields, guards, switches, and other devices in place and in proper working condition.

1.4.9DO NOT change the engine governor settings or overspeed the engine. Operating an engine at excessive speed may increase the hazard of personal injury.

1.4.10Disengage PTO before starting engine.

1.4.11Start the engine carefully with feet well away from the blades.

1.4.12Keep hands, feet, and clothing away from rotating parts while the mower is being operated.

1.4.13Stop engine, wait for all moving parts to stop, and remove key:

Before checking, cleaning or working on the mower.

After striking a foreign object (inspect the mower for damage and make repairs before restarting and operating the mower).

Before clearing blockages.

Whenever you leave the mower.

Stop the engine and wait for all moving parts to stop:

Before refueling.

Before dumping the grass catcher.

1.4.14Before stopping the engine, place the throttle control midway between the “slow” and “fast” positions. Allow the engine to run a minimum of 15 seconds; then stop the engine.

1.4.15The fuel system is provided with a shut-off valve. Shut off the fuel:

When the machine will not be used for a few days.

During transport to and from the job.

When parked inside a building.

1.4.16This mower was designed for one operator only. Keep all others away from mower during operation.

-6 -

Image 11
Contents For Serial Nos 440,000 & Higher Potential Hazard Exmark Parts PLUS Program Operators Manual Table of Contents Training SafetyYour Safety is Involved Safety Alert SymbolCarbon monoxide can kill you Potential Hazard Operation Safe Zone for Mowing There is no rollover protection when the roll bar is down Maintenance and Storage For Kawasaki Liquid-Cooled units Safety Signs Page Location RH Side on Top Specifications Cutting Deck Hydrostatic Ground Drive SystemTires Torque Requirements DimensionsUncrate Mower Install Rollover Protection System Roll BAR Assembly InstructionsLower Roll BAR Installation Machine is shipped with a filled lead acid battery Service BatteryUpper Roll BAR Installation Check Tire Pressure Install Drive WheelsInstall Motion Control Levers Position Discharge Chute Service Engine Service Engine CoolantMotion Control Positions Service Hydraulic OILOperation Instructions ControlsPotential Hazard Push the lever forward and down to disengage the brake Operating Instructions PRE-STARTTransporting Do not drive a unit on a public street or roadway Service Interval Daily Maintenance & AdjustmentsPeriodic Maintenance Service Interval Monthly Service Interval Daily or more often in dry conditions Blade Bolt Installation Service Interval Daily Service Interval 100 hrs Service Interval 50 hoursCoolant Plug Location Service Interval 40 hrs Service Interval 40 hrService Interval Refer to chart Lubrication ChartService Interval 160 hrs Service Interval Once YearlyCaster Wheel Assembly Service Interval After First 250 hrs Then yearly thereafter Service Interval As RequiredService Interval 500 hrs AdjustmentsCutting Height Position ANTI-SCALP Roller AdjustmentSelf-tensioning No adjustment necessary Swivel Adjustment Spring Compression AdjustmentMule Drive Belt Adjustment Belt Guide Positioning Brake AdjustmentThrottle Tension No adjustment necessaryReverse Indicator Adjustment Motion Control Adjustment Armrest Adjustment Caster AdjustmentEngine Coolant Disposal Mercury Switch DisposalWaste Disposal Motor OIL DisposalMower Cuts Unevenly Trouble ShootingBattery Disposal Mower Pulls Left or Right W/LEVERS Fully ForwardEngine Warning Systems Engine Troubleshooting TableProblem Electrical Diagram Hydraulic Diagram Limited Warranty Exmark Turf Equipment Page Page Service Record Page See EXMARK’S Complete Line of Products for Turf Care