Maintenance
5.Pry out seals, and inspect bearings for wear or damage and replace if necessary.
6.Pack the bearings with a NGLI grade #1
7.Insert one bearing, one new seal into the wheel.
Note: Seals (Exmark P/N
8.If the axle assembly has had both spacer nuts removed (or broken loose), apply a thread locking adhesive to one spacer nut and thread onto the axle with the wrench flats facing outward. Do Not thread spacer nut all of the way onto the end of the axle. Leave approximately 1/8 inch (3 mm) from the outer surface of the spacer nut to the end of the axle inside the nut.
9.Insert the assembled nut and axle into the wheel on the side of the wheel with the new seal and bearing.
10.With the open end of the wheel facing up, fill the area inside the wheel around the axle full of NGLI grade #1
11.Insert the second bearing and new seal into the wheel.
12.Apply a thread locking adhesive to the 2nd spacer nut and thread onto the axle with the wrench flats facing outward.
13.Torque the nut to
14.Reinstall the seal guards over the wheel hub and insert wheel into caster fork. Reinstall caster bolt and tighten nut fully.
Important: To prevent seal and bearing damage, check the bearing adjustment often. Spin the caster tire. The tire should not spin freely (more than 1 or 2 revolutions) or have any side play. If the wheel spins freely, adjust torque on spacer nut until there is a slight amount of drag. Reapply thread locking adhesive.
Check Spark Plugs
Service Interval: Every 200 hours
Remove spark plugs, check condition and reset gaps, or replace with new plugs. See Engine Owner’s Manual.
Change Fuel Filter
Service Interval: As required
A fuel filter is installed between the fuel tank and the engine. Replace when necessary.
Replacement Filters
Kawasaki | Kawasaki |
| P/N |
|
|
Note: It is important to reinstall the fuel line hoses and secure with plastic ties the same as they were originally installed at the factory to keep the fuel line away from components that could cause fuel line damage.
Change Hydraulic System Filter and Fluid
Service Interval: After the first 100 hours
Every 500 hours thereafter (Every 250 hours if using Mobil 1 15W50)
1.Stop engine, wait for all moving parts to stop, and allow engine to cool. Remove key and engage parking brake.
2.Locate the two filters under the transmissions. Remove filter guards.
3.Carefully clean area around filters. It is important that no dirt or contamination enter hydraulic system.
4.Unscrew filters to remove and allow oil to drain from drive system.
Important: Before reinstalling new filters, apply a thin coat of Exmark Premium Hydro Oil on the surface of the filters rubber seal.
Turn the filters clockwise until rubber seal contacts the filter adapter then tighten the filter an additional 3/4 to 1 full turn.
5.Remove the vent plug on each transmission and fill through expansion reservoir, when oil comes out of vent reinstall plug.
Exmark Premium Hydro Oil is recommended. Refer to the chart for an acceptable alternative:
33