Exmark PNS24KA523, PNS20KA443, PNS22KA483 manual Electric Clutch Adjustment, Removing the Shim

Maintenance

Figure 32

1.	Bolt	3.	Nut
2.	Spring	4.	Additional mounting
			holes

Up to five springs can be secured to the seat box with a nut and bolt, see Figure 32.

Refer to the Parts Manual for spring and hardware part numbers.

Electric Clutch Adjustment

Figure 33

1.	Armature	5.	Brake spacer
2.	Field shell	6.	Re-gap shim
3.	Rotor	7.	Brake pole

4.Brake mounting bolt

Removing the Shim:

1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake. Allow the machine to cool completely before starting these instructions.

2.Using a pneumatic line, blow out any debris from under the brake pole and around the brake spacers.

3.Check the condition of the wire harness leads, connectors, and terminals. Clean or repair as necessary.

4.Verify that 12V is present at the clutch connector when the PTO switch is engaged.

5.Measure the gap between the rotor and armature. If the gap is greater than .04 inch (1 mm), proceed with the following steps:

A.Loosen both brake mounting bolts one-half to one full turn (see Figure 34).

Note: Do Not remove the brake pole from the field shell/armature. The brake pole has worn to match the armature and needs to continue to match after the shim is removed to ensure proper brake torque.

Figure 34

1. Brake mounting bolt 2. Shim

B.Using needle nose pliers, or by hand, take hold of the tab and remove the shim (Do Not discard the shim until proper clutch function has been confirmed).

C.Using a pneumatic line, blow out any debris from under the brake pole and around the brake spacers.

D.Re-torque each bolt (M6 x 1) to 10 ft-lb (13 N-m) +/-0.5 ft-lb (0.7 N-m).

E.Using a 0.010 inch thick feeler gauge, verify that a gap is present between the rotor and armature face on both sides of the brake pole as shown. (Due to the way the rotor and armature faces wear (peaks and valleys) it is sometimes difficult to measure the true gap.)

40