ASSEMBLY
HOW TO INSTALL THE SEAT
Use the fasteners shown below to install the seat. The fasteners are shown at full size.
(A) | (B) |
1x45 | 18x16 |
1.Carefully remove the protective sleeve and the plastic bag from the seat. Do not damage the wire attached to the bottom of the seat.
2.Align the holes in the seat hinge to the holes in the seat (Figure 7). Fasten the seat to the seat hinge with the fasteners as shown. Tighten the fasteners.
3.Check the operating position of the seat. If the seat needs to be adjusted, loosen the hex nuts on the seat hinge. Slide the seat forward or backward along the seat adjusting holes as shown. To keep the seat straight, align the rear edge of the seat hinge with the marks on the top of the console. Tighten the hex nuts.
4.Fasten the connector to the wire harness. Make sure the tab on the connector locks into the wire harness.
WARNING: For correct and safe operation of the unit, fasten the connector to the wire harness. If the connector is not attached, the engine will not start.
Seat
Connector
Tab
Wire Harness
B A
Seat Hinge 
Seat Adjusting
Holes
Figure 7
HOW TO ASSEMBLE THE STEERING WHEEL
Use the fasteners shown below to install the steering wheel. The fasteners are shown at full size.
4.Some models have an optional decal in the parts bag. Attach the decal to the center of the steering wheel as shown.
(A) | (B) |
1x66 | 15x118 |
1.Make sure the front wheels point forward.
2.Some models have an optional bellows. Slide the bellows over the steering post. Make sure the collar of the bellows is on top (Figure 8).
3.Attach the steering wheel to the steering post with the fasten- ers. Tighten the fasteners.
Decal (Optional)
Steering Wheel
A 
B
Bellows
(Optional)
Steering Post
Figure 8
F−98857 | 14 |