Hayter Mowers 30-Dec manual HOW to Remove the Mower Housing, HOW to Install the Mower Housing

Page 28

MAINTENANCE

HOW TO REMOVE THE MOWER HOUSING

1.Move the lift lever to the lowest position.

2.Move the blade rotation control to the DISENGAGE position.

3.Remove the hair pins and the washers from the adjusting rods (Figure 23). See illustrations “C” and “D”.

4.Remove the hair pins and the washers from the suspension link and the adjuster plate. See illustrations “A” and “B”.

5.Remove the adjuster nut from the blade rotation control. See illustration “E”.

6.Disconnect the front hanger from the axle support. See il- lustration “F”.

7.If necessary, loosen the two belt guides at the stack pulley. See illustration “G”. Remove the mower drive belt from the stack pulley.

8.Pull the mower housing away from the right side of the unit.

HOW TO INSTALL THE MOWER HOUSING

1.Push the mower housing under the right side of the unit.

2.Put the mower drive belt around the stack pulley. Make sure the “V” side of the mower drive belt is against the stack pulley. Also, make sure the mower drive belt is not twisted.

3.Attach the front hanger to the axle support with the hanger rod. Fasten with the fasteners as shown. See illustration “F”.

4.Make sure the mower drive belt is between the stack pulley and the two belt guides. Tighten the two belt guides. See il- lustration “G”.

5.Fasten the adjuster nut to the blade rotation control with the hair pin. See illustration “E”.

6.Attach the suspension link and the adjuster plate to the lifter assembly. Fasten with the washers and hair pins. See illustra- tions “A” and “B”.

7.Attach the right and the left adjusting rods to the suspension brackets. Fasten with the washers and hair pins. See illustra- tions “C” and “D”.

8.Move the blade rotation control to the ENGAGE position. Make sure the mower drive belt is inside all the belt guides.

9.Make sure the mower housing is level. See the instructions on “How To Level The Mower Housing”.

10.Check the operation of the blade rotation control. See the in- structions on “How To Adjust The Blade Rotation Control”.

Blade Rotation

 

Control

Stack Pulley

Lifter Assembly

Lift Lever

Belt Guides

Stack Pulley

Blade Control

Rod

Hanger Rod

Mower Drive Belt

Front Hanger

Figure 23

 

F−98857

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents 12/30 Table of Contents International Symbols Safety Warning SymbolsTraining OWNER’S Information Slope Operation Safe Mowing Guide Safe Mowing Guide Safe Mowing Guide Steps to Follow Before MowingAssembly AssemblyHOW to Install the Front Wheels HOW to Assemble the Lift LeverMaintenance Free Battery HOW to Charge the Maintenance Free BatteryHOW to Install the Seat HOW to Assemble the Steering WheelHOW to Prepare the Engine Check the Level of the Mower HousingCheck the Tyres IMPORTANT! Before YOU Start MowingLocation of Controls OperationLift Lever HOW to USE the Shift Lever HOW to USE the Throttle ControlAttachments HOW to SET the Parking Brake HOW to Change the Cutting HeightHOW to Stop the Unit HOW to Transport the UnitHOW to Operate with the Mower Housing HOW to Operate the Unit on HillsHOW to Start the Engine HOW to Start with a Weak BatteryBefore Starting the Engine CarburettorOperating Tips Mowing and Bagging TipsMaintenance Maintenance ChartHOW to Check the Muffler General RecommendationsHOW to Sharpen the Blade HOW to Remove and Install the BladeInspect Blade HOW to Adjust the Blade Rotation Control HOW to Check and Adjust the Drive Brake HOW to Check and Adjust the ClutchHOW to Clean the Battery Where to Lubricate HOW to Check the Fuel FilterHOW to Remove the Mower Housing HOW to Install the Mower HousingFront to Back Adjustment HOW to Level the Mower HousingSide to Side Adjustment HOW to Replace the Motion Drive Belt RemovalHOW to Replace the Mower Drive Belt HOW to Replace the Fuse HOW to Replace the Light BulbHOW to Clean the Mower Housing BatteryTrouble Shooting Chart Problem The engine will not startIndex AFO Slope Guide −98857 Repair Parts Model CODE143P Repair Parts Chassis & Hood Key Description Model CODE143P Repair Parts Motion Drive Model CODE143P Motion DriveSteering Model CODE143P Repair Parts Steering Key Part DescriptionModel CODE143P Repair Parts Mower Housing Suspension Model CODE143P Repair Parts Mower Housing Suspension Model CODE143P Repair Parts Mower Housing Key Description Electricalrepair Parts Model CODE143P Repair Parts Electrical System Model CODE143P Repair Parts Engine Mount Model CODE143P Repair Parts Engine Mount −98857
Top Page Image Contents