Husqvarna PZ5426FX, 967004001, 966614001, PZ5430 warranty Tracking Knob, Cutting Height Pedals

CONTROLS

Tracking Knob

If the mower is not tracking straight, check the air pressure in both rear tires. Recommended air pressure for the rear tires is 15 psi (1 bar).

1.Tracking adjustments are made using the tracking bolt and tracking knob. The tracking bolt and tracking knob act as limiting devices for the motion control levers when in the full-forward position.

2.For preliminary tracking adjustment, move unit to an open, unobstructed area such as an empty parking lot or open field.

3.Back the tracking bolt out until flush with nut.

4.Loosen tracking knob out until flush with nut.

5.Test operate unit by driving it at full throttle and the full forward position on both motion control levers. Gradually turn in the tracking bolt on the right hand side until the unit noticeably starts drifting right.

6.Drive forward at full throttle with both motion control levers in the full forward position. Gradually turn in the tracking knob (left side) until unit tracks straight.

Cutting Height Pedals

The cutting height pedals release the deck lift to allow setting the desired deck height. Apply pressure to the lift pedal and rotate foot to also apply pressure to the release pedal, unlocking the deck lift.

For transport, push the lift pedal fully forward until the deck lift latches in the transport (highest) position.

8065-060

Tracking adjustment

2

1

8065-017

1.Lift pedal

2.Release pedal

Cut height selection pedals

23