Husqvarna 967009803, RZ46215 warranty Ignition Switch, Choke Control, Fuse

Page 20

CONTROLS

Ignition Switch

The ignition switch is placed on the control panel and is used to start and stop the engine.

On models equipped with headlights, turn the key clockwise to ACCESSORY for headlight use.

Choke Control

The choke control is used for cold starts to provide the engine with a richer fuel mixture.

For cold starts the control should be pulled up.

Fuse

The 20 amp primary fuse is located on the left hand side of the machine. It is accessed by tilting the seat forward. The fuse is a flat pin type used in automobiles.

8052-001

Ignition switch

8058-134

Choke control

8058-234

Fuse

20

Image 20

Contents

Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and Decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxRemove key before Performing any General Operation SafetySafety Instructions Never take passengers Personal Safety Equipment Slope OperationBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance With water Transport Spark ArrestorControls Control LocationsSteering Control Levers Throttle Control Blade SwitchParking Brake Fuse Ignition SwitchChoke Control Fuel Tank Cutting Height Adjuster Fuel Shut Off ValveBypass Linkages Always raise the deck to the highest position for transportSeat Adjustment Lever Seat should not be adjusted while unit is in motionHour Meter Tracking KnobSteering OperationTraining Before Starting Starting the Engine Place controls in neutral position Press in and turn the ignition key to the start position To remove cables, reverse order Weak BatteryJumper Cables Use Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine By Hand Maintenance Maintenance ScheduleDaily Maintenance interval Least Hours Once Each Before AfterDaily At least Maintenance Once Interval Each Hours Before After 100 300Battery Replacing batterySafety System Tire Pressures Anti-scalp RollersDeck Belt Removal Deck Belt InstallationBelts Cutting Blades Adjusting the Mower Deck Leveling deckCleaning Removal and installation of caster wheelUse protective glasses when cleaning and washing Caster WheelsGeneral LubricationLubrication Schedule Engine Oil Change Wheel and Deck ZerksFront Wheel Mount Front Wheel BearingsTransmission Deck SpindlesMaintenance Section TroubleshootingProblem Cause Troubleshooting Winter Storage ServiceStorage Schematics Technical Data Torque SpecificationsAccessories Standard HardwareDimensions EngineTransmission FrameConformity Certificates USA requirementsService Journal Delivery ServiceHour Service After the First 10 HoursPerform the 25-hour service At Least Once Each Year Service Journal Page 115 621427 Rev a 2013-08-15

Related manuals

Manual 40 pages 45.17 Kb