Husqvarna RZ46215, 967009803 warranty Fuel Tank

Page 21

CONTROLS

Fuel Tank

Read the safety instructions before refueling. The machine has one fuel tank, just behind the console. The tank capacity is 3.5 gallons (13.25 liters).

Regularly check the gas cap gasket for damage and keep the cap properly tightened.

The engine will run on a minimum of 85-octane unleaded gasoline (no oil mix). Environmentally adapted alkylate gasoline can be used. See also Technical Data concerning ethanol fuel. Methanol fuel is not allowed. Do not use E85 alcohol based fuel. Damage to engine and components may occur.

When operating in temperatures below 32° F. (0° C.), use fresh, clean winter grade gasoline to insure good cold weather starting.

WARNING!

Gasoline is highly flammable. Observe caution and fill the tank outdoors (see the safety instruction).

WARNING!

The engine and the exhaust system, become very hot during operation.

Risk for burns if touched.

Allow engine and exhaust system to cool before refueling.

WARNING!

Fill to bottom of filler neck. Do not overfill. Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

8058-021

Fuel tank

IMPORTANT INFORMATION

Experience indicates that alcohol blended fuels (called gasohol, ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel the next season. See Storage Instructions for additional information. Never use engine or carburetor cleaners in the fuel tank or permanent damage may occur.

21

Image 21 Contents
Operator Manual All rights reserved Contents Page Introduction Manufacturing Number Good ServiceXxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxx Symbols and DecalsRemove key before Performing any Safety Safety InstructionsGeneral Operation Never take passengers Slope Operation Personal Safety EquipmentBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance With water Spark Arrestor Transport Control Locations ControlsSteering Control Levers Blade Switch Parking BrakeThrottle Control Ignition Switch Choke ControlFuse Fuel Tank Fuel Shut Off Valve Cutting Height AdjusterBypass Linkages Always raise the deck to the highest position for transportSeat should not be adjusted while unit is in motion Seat Adjustment LeverHour Meter Tracking KnobOperation TrainingSteering Before Starting Starting the Engine Place controls in neutral position Press in and turn the ignition key to the start position Weak Battery Jumper Cables UseTo remove cables, reverse order Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine By Hand Maintenance Schedule MaintenanceDaily Maintenance interval Least Hours Once Each Before AfterBefore After 100 300 Daily At least Maintenance Once Interval Each HoursReplacing battery BatterySafety System Anti-scalp Rollers Tire PressuresDeck Belt Installation BeltsDeck Belt Removal Cutting Blades Leveling deck Adjusting the Mower DeckRemoval and installation of caster wheel CleaningUse protective glasses when cleaning and washing Caster WheelsLubrication Lubrication ScheduleGeneral Wheel and Deck Zerks Engine Oil ChangeFront Wheel Mount Front Wheel BearingsDeck Spindles TransmissionTroubleshooting Problem CauseMaintenance Section Troubleshooting Service StorageWinter Storage Schematics Torque Specifications Technical DataAccessories Standard HardwareEngine DimensionsTransmission FrameUSA requirements Conformity CertificatesDelivery Service Service JournalAfter the First 10 Hours Hour ServicePerform the 25-hour service At Least Once Each Year Service Journal Page 115 621427 Rev a 2013-08-15
Related manuals
Manual 40 pages 45.17 Kb