MAINTENANCE
V-belts
Check every 100 hours of operation. Check for severe cracking and large nicks.
NOTE: The belt will show some small cracks in normal operation.
The belts are not adjustable. Replace belts if they begin to slip from wear.
Deck Belt Removal
1.Park on a level surface. Apply parking brake.
2.Lower the deck into the lowest cutting position.
3.Remove bolts from belt shields and remove shields.
4.Remove any dirt or grass that may have accumulated around the cutter housings and entire deck surface.
5.Loosen the nut securing the belt guide. Note the position of the belt guide for reinstallation.
6.Push inward on the idler arm to release the tension on the belt.
7.Carefully slip the belt over the top of the cutter housing pulleys and remove belt from the deck.
| 1 |
| 2 |
3 | 1 |
| |
|
1.Belt shields
2.Belt guide
3.Idler arm Removing the deck belt
Deck Belt Installation
NOTE: For ease in installing the deck belt, refer to the routing decal on the top of the deck.
1.Wrap the deck belt around the electric clutch pulley that is located on the engine shaft.
2.Route the belt forward and up onto the deck.
3.Place belt around spring loaded idler pulley.
4.Wrap the belt around the stationary idler pulley and around the mandrel housings.
5.Push inward on the idler arm and carefully route belt over stationary idler pulley. Once the belt is properly routed, slowly release the idler arm to tension belt.
6.Double check belt routing to make sure it matches the decal affixed to the deck, and the belt does not have any twist. Correct if needed.
7.Tighten the belt guide and replace belt shields on both mandrel housings and secure with fasteners. NOTE: The belt guide should be perpendicular to the belt when installation is complete.
Belt routing
40