Husqvarna 967009803, RZ46215 warranty Press in and turn the ignition key to the start position

Page 28

OPERATION

8. Press in and turn the ignition key to the start position.

IMPORTANT INFORMATION

Do not run the starter for more than 5 seconds each time. If the engine does not start, wait approximately 10 seconds before retrying.

8050-780

Turn to the start position

9.When the engine starts, immediately release the ignition key back to the run position. Push the choke control in gradually when the engine has started.

WARNING!

Engine exhaust and certain vehicle components contain or emit chemicals considered to cause cancer, birth defects or other reproductive system damage. The engine exhaust contains carbon monoxide, which is a odorless, colorless, poisonous gas. Do not use the machine in enclosed spaces.

8050-781

Return to run position

10.Set the engine speed with the throttle. Allow the engine to run at a moderate speed, approximately mid throttle, for 3-5 minutes before loading it too heavily. USE FULL THROTTLE WHEN MOWING (no choke).

8058-149

Set the engine speed

28

Image 28 Contents
Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and Decals Xxxx xxxxxx xxxxx xxxx Xxxxxx xxxxxxxxx. xx xxxxxxxxRemove key before Performing any Safety Instructions SafetyGeneral Operation Never take passengers Personal Safety Equipment Slope OperationBe extra cautious when driving on slopes Safe Handling of Gasoline General Maintenance With water Transport Spark ArrestorControls Control LocationsSteering Control Levers Parking Brake Blade SwitchThrottle Control Choke Control Ignition SwitchFuse Fuel Tank Cutting Height Adjuster Fuel Shut Off ValveBypass Linkages Always raise the deck to the highest position for transportSeat Adjustment Lever Seat should not be adjusted while unit is in motionHour Meter Tracking Knob Training Operation Steering Before Starting Starting the Engine Place controls in neutral position Press in and turn the ignition key to the start position Jumper Cables Use Weak BatteryTo remove cables, reverse order Running Operating On Hills Mowing Tips Stopping the Engine Moving Machine By Hand Maintenance Maintenance ScheduleDaily Maintenance interval Least Hours Once Each Before AfterDaily At least Maintenance Once Interval Each Hours Before After 100 300Battery Replacing batterySafety System Tire Pressures Anti-scalp RollersBelts Deck Belt InstallationDeck Belt Removal Cutting Blades Adjusting the Mower Deck Leveling deckCleaning Removal and installation of caster wheelUse protective glasses when cleaning and washing Caster WheelsLubrication Schedule LubricationGeneral Engine Oil Change Wheel and Deck ZerksFront Wheel Mount Front Wheel BearingsTransmission Deck SpindlesProblem Cause TroubleshootingMaintenance Section Troubleshooting Storage ServiceWinter Storage Schematics Technical Data Torque SpecificationsAccessories Standard HardwareDimensions EngineTransmission FrameConformity Certificates USA requirementsService Journal Delivery ServiceHour Service After the First 10 HoursPerform the 25-hour service At Least Once Each Year Service Journal Page 115 621427 Rev a 2013-08-15
Related manuals
Manual 40 pages 45.17 Kb