Husqvarna 600CRT owner manual Tools Required for Assembly, OPERATOR’S Position See Fig

Page 5

ASSEMBLY

Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1) Utility knife

(1)Tire pressure gauge

(1)Pair of pliers

(1)9/16" wrench

OPERATOR’S POSITION (See Fig. 1)

When right or left hand is mentioned in this manual, it means when you are in the operating position (standing behind tiller handles).

FRONT

LEFT

RIGHT

OPERATOR’S

POSITION

FIG. 1

CONTENTS OF HARDWARE PACK
(2) Handle Locks	(1) Carriage Bolt	(1) Center Locknut
	3/8-16 UNC x 1 Grade 5	3/8-16 UNC
(1) Flat Washer 13/32 x 1 x 11 Gauge	(1) Handle Lock Lever	(1) Hairpin Clip
(1) Pivot Bolt
3/8-16 UNC Grade 5	Extra Shear Pins & Clips
	5

Image 5

Contents 600CRT Training Maintenance and StoragePreparation OperationCustomer Responsibilities Product SpecificationsTable of Contents OPERATOR’S Position See Fig AssemblyTools Required for Assembly Unpacking Carton See Fig Install Handle See Figs , 4,Connect Shift ROD See Fig Attach Clutch Cable See FigRemove Tiller from Crate Check Tire PressureKnow Your Tiller Meets Ansi Safety RequirementsOperation Tine Operation with Wheel Drive HOW to USE Your TillerForward Wheels ONLY/TINES Stopped Reverse Wheels ONLY/TINES StoppedTurning Before Starting EngineTo Transport ADD GasolineTo Start Engine See Fig Tine Shear PinsCultivating Tilling HintsCustomer Responsibilities Lubrication ChartGeneral Recommendations Before Each USECooling System See Fig EngineAIR Filter See Fig Tiller Service and AdjustmentsCleaning To Replace Ground Drive Belt See Fig Ground Drive Belt Adjustment See FigTo Remove Belt Guard See Fig Tine Replacement See Figs , 25, To Adjust Carburetor To Adjust Throttle Control Cable See FigOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsHandle Assembly Repair PartsKEY Part Description NO. no MAINFRAME, Left SideMAINFRAME, Right Side 532154354 Transmission Assembly Includes Key Nos Tine Shield Tine Assembly Decals Tiller Model no CRT 954140070AHusqvarna Forest & Garden CO Warranty StatementRev 9.28.98 TR