Husqvarna 600CRT owner manual To Adjust Throttle Control Cable See Fig, To Adjust Carburetor

Page 17

SERVICE AND ADJUSTMENTS

ENGINE

TO ADJUST THROTTLE CONTROL CABLE (See Fig. 27)

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, proceed as follows:

•With engine not running, move remote throttle control lever to “FAST” position.

•If throttle lever on engine touches high speed stop, no further adjustment is necessary. If throttle lever does not touch high speed stop, continue with adjustment procedure.

•Loosen cable clamp screw.

•Move throttle lever up until it touches high speed stop, and hold in this position.

•Tighten cable clamp screw securely.

TO ADJUST CARBURETOR

The carburetor has been preset at the factory and adjust- ment should not be necessary. However, engine perfor- mance can be affected by differences in fuel, temperature, altitude or load. If the carburetor does need adjustment, contact your nearest authorized service center/department

IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACT YOUR N E A R E S T A U T H O R I Z E D S E R V I C E C E N T E R / DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.

FUEL TANK

CLAMP SCREW

CASING

AND WIRE

GOVERNOR

CONTROL

LEVER

FIG. 27

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents 600CRT Training Maintenance and StoragePreparation OperationCustomer Responsibilities Product SpecificationsTable of Contents OPERATOR’S Position See Fig AssemblyTools Required for Assembly Unpacking Carton See Fig Install Handle See Figs , 4,Connect Shift ROD See Fig Attach Clutch Cable See FigRemove Tiller from Crate Check Tire PressureKnow Your Tiller Meets Ansi Safety RequirementsOperation Tine Operation with Wheel Drive HOW to USE Your TillerForward Wheels ONLY/TINES Stopped Reverse Wheels ONLY/TINES StoppedTurning Before Starting EngineTo Transport ADD GasolineTo Start Engine See Fig Tine Shear PinsCultivating Tilling HintsCustomer Responsibilities Lubrication ChartGeneral Recommendations Before Each USECooling System See Fig EngineAIR Filter See Fig Tiller Service and AdjustmentsCleaning To Replace Ground Drive Belt See Fig Ground Drive Belt Adjustment See FigTo Remove Belt Guard See Fig Tine Replacement See Figs , 25, To Adjust Carburetor To Adjust Throttle Control Cable See FigOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsHandle Assembly Repair PartsKEY Part Description NO. no MAINFRAME, Left SideMAINFRAME, Right Side 532154354 Transmission Assembly Includes Key Nos Tine Shield Tine Assembly Decals Tiller Model no CRT 954140070AHusqvarna Forest & Garden CO Warranty StatementRev 9.28.98 TR
Top Page Image Contents