CUSTOMER RESPONSIBILITIES
MUFFLER
Do not operate tiller without muffler. Do not tamper with exhaust system. Damaged mufflers or spark arresters could create a fire hazard. Inspect periodically and replace if necessary. If your engine is equipped with a spark arrester screen assembly, remove every 50 hours for cleaning and inspection. Replace if damaged.
SPARK PLUG
Replace spark plugs at the beginning of each tilling season or after every 50 hours of use, whichever comes first. Spark plug type and gap setting is shown in “PRODUCT SPECI- FICATIONS” on page 3 of this manual.
TRANSMISSION
Your transmission is sealed and will only require lubrication if serviced.
CLEANING
•Clean engine, wheels, finish, etc. of all foreign matter.
•Keep finished surfaces and wheels free of all gasoline, oil, etc.
•Protect painted surfaces with automotive type wax.
We do not recommend using a garden hose to clean your unit unless the muffler, air filter and carburetor are covered to keep water out. Water in engine can result in a shortened engine life.
SERVICE AND ADJUSTMENTS
CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into contact with plug.
TILLER
TO ADJUST HANDLE HEIGHT (See Fig. 20)
Select handle height best suited for your tilling conditions. Handle height will be different when tiller digs into soil.
•First loosen handle lock lever.
•Handle can be positioned at different settings between “HIGH” and “LOW” positions.
•Retighten handle lock lever securely after adjusting.
HANDLE |
(HIGH POSITION) |
HANDLE |
LOCK |
LEVER |
HANDLE |
(LOW POSITION) |
FIG. 20
TIRE CARE
CAUTION: When mounting tires, un- less beads are seated, overinflation can cause an explosion.
TO REMOVE WHEEL (See Fig. 21)
•Place blocks under transmission to keep tiller from tipping.
•Remove outer side shield by removing nuts “A” and “B”.
•Remove inner side shield by removing nuts “C” and “D”.
•Remove hairpin clip and clevis pin from wheel.
•Remove wheel and tire.
•Repair tire and reassemble.
CLEVIS |
|
PIN |
|
| NUT “C” |
| NUT |
| “D” |
HAIRPIN |
|
CLIP |
|
NUT “B” |
|
| INNER SIDE |
| SHIELD |
| OUTER |
NUT “A” | SIDE |
| SHIELD |
• Maintain 20 PSI (1.4 kg/cm2) of tire pressure. If tire | FIG. 21 |
pressures are not equal, tiller will pull to one side. |
|
•Keep tires free of gasoline or oil which can damage 14 rubber.