Husqvarna 965167501, 965167936, 965168601 manual 435e, 440e

Page 14

GENERAL SAFETY PRECAUTIONS

Tension the chain as tightly as possible, but not so tight that you cannot pull it round freely by hand.

435

Loosen the bar nut that holds the clutch cover and chain brake. Use the combination spanner. Then retighten the bar nut as tightly as you can by hand.

Raise the tip of the bar and stretch the chain by tightening the chain tensioning screw using the combination spanner. Tighten the chain until it does not sag from the underside of the bar.

Use the combination spanner to tighten the bar nut while holding up the tip of the bar. Check that you can pull the saw chain round freely by hand, and that there is no slack on the underside of the bar.

The position of the chain tensioning screw on our chain saws varies from model to model. See instructions under the heading What is what? to find out where it is on your model.

435e, 440e

Release the knob by folding it out.

Turn the knob anti clockwise to loosen the bar cover.

Adjust the tension on the chain by turning the wheel down (+) for tighter tension and up (-) to loosen the tension.

Tighten the bar clutch by turning the knob clockwise.

14 – English

115 10 82-26 Rev.2 2008-06-03

Image 14
Contents 435 435e 440e EnglishSymbols in the operator’s manual KEY to SymbolsSymbols on the machine Contents Introduction Dear CustomerWhat is WHAT? What is what on the chain saw?General Safety Precautions Before using a new chain sawPersonal protective equipment Machine′s safety equipmentAlways use common sense Chain brake and front hand guardGeneral Safety Precautions Throttle lockout Chain catcherVibration damping system Stop switchRight hand guard MufflerCutting equipment designed to reduce kickback Cutting equipmentGeneral rules Sharpening your chain and adjusting depth gauge setting General information on sharpening cutting teethTensioning the chain 435 435e, 440eFilling with chain oil Lubricating cutting equipmentWhich could lead to serious, even fatal injuries Chain oil Checking chain lubricationChecking wear on cutting equipment Chain drive sprocketNeedle bearing lubrication 435 AssemblyFitting the bar and chain 435e, 440eFitting a spike bumper Fuel Handling FuelTransport and storage Fuel safetyFuelling Long-term storageStarting Starting and StoppingStarting and stopping Stopping Before use Basic safety rulesWorking Techniques General working instructionsGeneral rules Basic cutting technique TermsSafe distance Tree felling techniqueLimbing Directional cuts Felling directionClearing the trunk and preparing your retreat Felling cut Freeing a trapped tree General adviceFreeing a tree that has fallen badly Cutting trees and branches that are in tensionCutting the trunk into logs How to avoid kickbackWhat is kickback? General MaintenanceCarburettor adjustment Checking the inertia brake release ImmediatelyMuffler Tensioning the recoil spring StarterReplacing the starter cord Fitting the starter Air filterReplacing the return and drive springs Needle bearing lubrication Spark plugLubricating the bar tip sprocket Cooling systemWinter use Air Injection centrifugal cleaningTemperature -5C or colder Maintenance schedule Daily maintenance Weekly maintenance Monthly maintenanceTechnical Data Technical dataBar and chain combinations Saw chain filing and file gaugesEN ISO 12100-22003, Cispr 122005, EN ISO EC-declaration of conformityApplies to Europe only ´z+S6¶68¨ Page 1151082-26