Husqvarna 965168601, 965167936, 965167501 manual Stopping

Page 22

STARTING AND STOPPING

•Never start a chain saw unless the bar, chain and all covers are ﬁtted correctly. See instructions under the heading Assembly. Without a bar and chain attached to the chain saw the clutch can come loose and cause serious injury.

•The chain brake should be activated when starting. Se instructions under the heading Start and stop. Do not drop start. This method is very dangerous because you may lose control of the saw.

•Never start the machine indoors. Exhaust fumes can be dangerous if inhaled.

•Observe your surroundings and make sure that there is no risk of people or animals coming into contact with the cutting equipment.

•Always hold the saw with both hands. The right hand should be on the rear handle, and the left hand on the front handle. All people, whether right or left handed, should use this grip. Use a ﬁrm grip with thumbs and ﬁngers encircling the chain saw handles.

•The chain brake is released by moving the front hand guard marked ”PULL BACK TO RESET” back, towards the front handle.

Stopping

Stop the engine by pushing the start/stop switch down.

CAUTION! The start/stop switch automatically returns to run position. To avoid involuntary start up, the spark plug cap must always be removed from the spark plug when the machine is unsupervised.

22 – English

115 10 82-26 Rev.2 2008-06-03

Image 22

Contents 435 435e 440e EnglishSymbols on the machine KEY to SymbolsSymbols in the operator’s manual Contents Introduction Dear CustomerWhat is WHAT? What is what on the chain saw?General Safety Precautions Before using a new chain sawPersonal protective equipment Machine′s safety equipmentAlways use common sense Chain brake and front hand guardGeneral Safety Precautions Throttle lockout Chain catcherVibration damping system Stop switchRight hand guard MufﬂerGeneral rules Cutting equipmentCutting equipment designed to reduce kickback Sharpening your chain and adjusting depth gauge setting General information on sharpening cutting teethTensioning the chain 435 435e, 440eFilling with chain oil Lubricating cutting equipmentWhich could lead to serious, even fatal injuries Chain oil Checking chain lubricationNeedle bearing lubrication Chain drive sprocketChecking wear on cutting equipment 435 AssemblyFitting the bar and chain 435e, 440eFitting a spike bumper Fuel Handling FuelTransport and storage Fuel safetyFuelling Long-term storageStarting and stopping Starting and StoppingStarting Stopping Before use Basic safety rulesWorking Techniques General working instructionsGeneral rules Basic cutting technique TermsLimbing Tree felling techniqueSafe distance Clearing the trunk and preparing your retreat Felling directionDirectional cuts Felling cut Freeing a trapped tree General adviceFreeing a tree that has fallen badly Cutting trees and branches that are in tensionWhat is kickback? How to avoid kickbackCutting the trunk into logs Carburettor adjustment MaintenanceGeneral Checking the inertia brake release ImmediatelyMufﬂer Replacing the starter cord StarterTensioning the recoil spring Replacing the return and drive springs Air ﬁlterFitting the starter Needle bearing lubrication Spark plugLubricating the bar tip sprocket Cooling systemTemperature -5C or colder Air Injection centrifugal cleaningWinter use Maintenance schedule Daily maintenance Weekly maintenance Monthly maintenanceTechnical Data Technical dataBar and chain combinations Saw chain ﬁling and ﬁle gaugesApplies to Europe only EC-declaration of conformityEN ISO 12100-22003, Cispr 122005, EN ISO ´z+S6¶68¨ Page 1151082-26