Husqvarna 965167501, 965167936, 965168601 manual Checking the inertia brake release, Immediately

Page 32

MAINTENANCE

Checking the inertia brake release

Place the chain saw, with the engine switched off, on a stump or other stable surface. Release the front handle and let the saw fall by its own weight, rotating around the rear handle towards the stump.

When the bar hits the stump the brake should be applied.

Checking the brake trigger

Place the chain saw on firm ground and start it. Make sure the chain does not touch the ground or any other object. See the instructions under the heading Start and stop.

Grasp the chain saw firmly, wrapping your fingers and thumbs around the handles.

Apply full throttle and activate the chain brake by tilting your left wrist forward onto the front hand guard. Do not let go of the front handle. The chain should stop

immediately.

Throttle lockout

Make sure the throttle control is locked at the idle setting when the throttle lockout is released.

Press the throttle lockout and make sure it returns to its original position when you release it.

Check that the throttle control and throttle lockout move freely and that the return springs work properly.

Start the chain saw and apply full throttle. Release the throttle control and check that the chain stops and remains stationary. If the chain rotates when the throttle control is in the idle position you should check the carburettor idle adjustment.

Chain catcher

Check that the chain catcher is not damaged and is firmly attached to the body of the chain saw.

32 – English

115 10 82-26 Rev.2 2008-06-03

Image 32
Contents 435 435e 440e EnglishSymbols in the operator’s manual KEY to SymbolsSymbols on the machine Contents Introduction Dear CustomerWhat is WHAT? What is what on the chain saw?General Safety Precautions Before using a new chain sawMachine′s safety equipment Always use common sensePersonal protective equipment Chain brake and front hand guardGeneral Safety Precautions Throttle lockout Chain catcherStop switch Right hand guardVibration damping system MufflerCutting equipment designed to reduce kickback Cutting equipmentGeneral rules Sharpening your chain and adjusting depth gauge setting General information on sharpening cutting teethTensioning the chain 435 435e, 440eLubricating cutting equipment Which could lead to serious, even fatal injuries Chain oilFilling with chain oil Checking chain lubricationChecking wear on cutting equipment Chain drive sprocketNeedle bearing lubrication Assembly Fitting the bar and chain435 435e, 440eFitting a spike bumper Fuel Handling FuelFuel safety FuellingTransport and storage Long-term storageStarting Starting and StoppingStarting and stopping Stopping Basic safety rules Working TechniquesBefore use General working instructionsGeneral rules Basic cutting technique TermsSafe distance Tree felling techniqueLimbing Directional cuts Felling directionClearing the trunk and preparing your retreat Felling cut General advice Freeing a tree that has fallen badlyFreeing a trapped tree Cutting trees and branches that are in tensionCutting the trunk into logs How to avoid kickbackWhat is kickback? General MaintenanceCarburettor adjustment Checking the inertia brake release ImmediatelyMuffler Tensioning the recoil spring StarterReplacing the starter cord Fitting the starter Air filterReplacing the return and drive springs Spark plug Lubricating the bar tip sprocketNeedle bearing lubrication Cooling systemWinter use Air Injection centrifugal cleaningTemperature -5C or colder Maintenance schedule Daily maintenance Weekly maintenance Monthly maintenanceTechnical Data Technical dataBar and chain combinations Saw chain filing and file gaugesEN ISO 12100-22003, Cispr 122005, EN ISO EC-declaration of conformityApplies to Europe only ´z+S6¶68¨ Page 1151082-26