Husqvarna 96045001502, 532 43 00-01 owner manual To Level Mower

Page 22

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER

Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 34)

•With all tires properly inflated and if your lawn appears unevenly cut, determine which side of mower is cutting lower.

NOTE: As desired, you can raise the low side of mower or lower the high side.

•Go to side of mower you wish to adjust.

•With a 3/4" or adjustable wrench, turn lift link adjust- ment nut (A) to the left to lower the mower, or, to the right to raise the mower.

 

A

Turn nut right

Turn nut left

to raise mower

to lower mower

Fig. 34

NOTE: Each full turn of adjustment nut will change mower height about 3/16".

•Test your adjustment by mowing some uncut grass and visually checking the appearance. Readjust, if necessary, until you are satisfied with the results.

PRECISION SIDE-TO-SIDE ADJUSTMENT (See Fig. 35)

•With all tires properly inflated, park tractor on level ground or driveway.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

•Raise mower to its highest position.

•At both sides of mower, position blade at side and measure the distance (A) from bottom edge of blade to the ground. The distance should be the same on both sides.

 

02966

A

A

Fig. 35

•If adjustment is necessary, see steps in Visual Adjust- ment instructions above.

•Recheck measurements, adjust if necessary until both sides are equal.

FRONT-TO-BACK ADJUSTMENT (See Figs. 36 & 37) IMPORTANT: Deck must be level side-to-side.

To obtain the best cutting results, the mower blades should be adjusted so the front tip is 1/8" to 1/2" lower than the rear tip when the mower is in its highest position.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

•Raise mower to highest position.

•Position any blade so the tip is pointing straight forward. Measure distance (B) to the ground at front and rear tip of the blade.

BB

Fig. 36

•If front tip of blade is not 1/8" to 1/2" lower than the rear tip, go to the front of tractor.

•With an 11/16" or adjustable wrench, loosen jam nut A several turns to clear adjustment nut B.

•Witha3/4"oradjustablewrench,turnfrontlinkadjustment nut (B) clockwise (tighten) to raise the front of mower, or, counterclockwise (loosen) to lower the front mower.

B

A

TIGHTEN ADJUST

LOOSEN

ADJUST NUT

NUT B TO RAISE

B TO LOWER

MOWER

 

02950

MOWER

 

LOOSEN JAM NUT A FIRST

 

Fig. 37

NOTE: Each full turn of the adjustment nut will change mower height about 1/8".

•Recheck measurements, adjust if necessary until front tip of blade is 1/8" to 1/2" lower than the rear tip.

•Hold adjustment nut in position with wrench and tighten jam nut securely against adjustment nut.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents LGT2554 General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Unassembled Parts AssemblyTools Required for Assembly ToremovetractorfromcartonSET Parking Brake Lever and Lower AT- Tachment Lift See Fig To Adjust Seat See FigTo Install Mower and Drive Belt See Figs Assemble Front Gauge Wheel W to Front of Mower See FigSlide Mower Under Tractor See Fig Install ANTI-SWAY BAR S if Equipped SeeANTI-SWAY BAR S Attach Rear Lift Links C See Fig Attach Mower Side Suspension Arms a to Chassis See FigAttach Front Link E See Fig Check Deck Levelness Install Belt on Engine Clutch Pulley M SeeCheck Tire Pressure CheckforproperpositionofallbeltsOperation Know Your Tractor DPH AC JStopping See Fig HOW to USE Your TractorTo SET Parking BRAKESee Fig To USE Throttle Control See FigTo Move Forward and Backward See Fig To Adjust Gauge Wheels See FigTo Adjust Mower Cutting Height See Fig To Operate MowerTo Operate on Hills Service REMINDER/HOUR MeterReverse Operation System ROS See Fig To Transport SeeADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Purge TransmissionGeneral Recommendations MaintenanceMaintenance ScheduleBlade Care BatteryTractor Blade Removal See FigEngine IN-LINE Fuel Filter See Fig CleaningDeck Washout Port See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower To Replace Mower Blade Drive Belt See FigTo Level Mower Front Wheel TOE-IN/CAMBER To Replace Motion Drive Belt See FigTo Check Brake To Remove Wheel See FigTo Attach Jumper Cables Transaxle Motion Control Lever Neutral Adjustment See FigTo Start Engine with a Weak Battery See Fig To Remove CABLES, Reverse OrderTransmission Fuel System StorageOther Engine OILProblem Cause Correction Fires when turn To run when operBattery will not Engine continuesWheels and Tires DecalsKEY Part Description Schematic SCH12Electrical KEY Part Description Chassis 532 40 873 90Drive 874 49 532 42Engine 30!2+ª!22%34%2ª+4Seat Assembly 532 42 SeatSteering Assembly 532 41 Wheel, Steering 532 19 Mower Deck 532 40 31-25 Deck Weldment Mower Mower Lift Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXLimitations and Exclusions HOW to Obtain Service Consumer Wheeled Warranty Chart 06.21.10 JA

532 43 00-01, 96045001502 specifications

The Husqvarna 96045001502,532 43 00-01 is an advanced lawn mower designed for homeowners seeking efficiency, durability, and exceptional cutting performance. This model stands out for its robust features and innovative technologies that make lawn maintenance a breeze.

One of the key features of the Husqvarna 96045001502 is its powerful engine. Equipped with a reliable and efficient gasoline engine, it delivers optimal performance and allows the mower to tackle various terrain types effortlessly. The engine is designed to provide consistent power, ensuring that the mower can handle thick grass and tough conditions without compromising on its cutting capability.

The cutting deck is another highlight of this model. The Husqvarna lawn mower boasts a wide cutting deck that ensures a clean and even cut across the lawn. This feature minimizes the number of passes needed to achieve a well-manicured appearance, saving valuable time while enhancing lawn aesthetics. Furthermore, the deck's design promotes efficient grass discharge, ensuring that clippings are evenly distributed across the lawn or can be easily collected for mulching purposes.

In terms of ergonomics, the Husqvarna 96045001502 is designed with user comfort in mind. The adjustable handlebar system allows users of different heights to find a comfortable grip, reducing fatigue during prolonged use. Additionally, the mower is lightweight yet sturdy, making it easy to maneuver around obstacles and navigate through tight spaces in the yard.

Safety is also a priority with this mower. It comes equipped with features such as automatic blade stop technology, which ensures the blades come to a halt instantly when the user releases the handle. This mechanism reduces the risk of accidents, making it a safe choice for families and inexperienced users alike.

The Husqvarna 96045001502,532 43 00-01 incorporates several innovative technologies that enhance its performance. The Air Injection system, for example, helps to keep the air filter clean longer by separating large debris from the airflow. This extends the life of the engine and maintains performance over time.

In summary, the Husqvarna 96045001502,532 43 00-01 is an exceptional lawn mower that combines power, efficiency, and user-friendly features. With its durable construction, ergonomic design, and advanced technologies, it stands out as a top choice for homeowners looking to maintain a beautiful, healthy lawn with ease.
Top Page Image Contents