Husqvarna 96045001502 HOW to USE Your Tractor, To SET Parking BRAKESee Fig, Stopping See Fig

Page 12

OPERATION

The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask worn over spectacles.

HOW TO USE YOUR TRACTOR

TO SET PARKING BRAKE(See Fig. 16)

Your tractor is equipped with an operator presence sens- ing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.

•Depress brake pedal (B) all the way down and hold.

•Pull parking brake lever (C) up and hold, release pres- sure from brake pedal (B), then release parking brake lever. Pedal should remain in brake position. Make sure parking brake will hold tractor secure.

C

B

Fig. 16

STOPPING (See Fig. 17)

MOWER BLADES -

•To stop mower blades, place attachment clutch control in the “DISENGAGED” position ().

 

 

 

 

(

 

) ATTACHMENT

( ) ATTACHMENT

 

 

 

 

CLUTCH SWITCH

CLUTCH SWITCH

 

 

“DISENGAGED”

“ENGAGED”

 

 

 

 

Fig. 17

GROUND DRIVE -

•To stop ground drive, depress brake pedal all the way down.

•Move motion control lever (J) to neutral position.

ENGINE -

•Move throttle control (D) between half and full speed (fast) position.

NOTE: Failure to move throttle control between half and full speed (fast) position, before stopping, may cause engine to “backfire”.

•Turn ignition key (F) to “STOP” position and remove key. Always remove key when leaving tractor to prevent unauthorized use.

•Never use the choke to stop the engine.

IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY POSITION OTHER THAN "STOP" WILL CAUSE THE BATTERY TO DISCHARGE AND GO DEAD.

NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause “browning” of grass. To eliminate this possibility, al- ways stop engine when stopping tractor on grass areas.

CAUTION: Always stop tractor com- pletely, as described above, and set parking brake before leaving the opera- tor's position.

TO USE THROTTLE CONTROL (See Fig. 18)

Always operate engine at full speed (fast).

•Operating engine at less than full speed (fast) reduces engines operating efficiency.

•Full speed (fast) offers the best bagging and mower performance.

D

N

F

Fig. 18

TO USE CHOKE CONTROL (See Fig. 18)

Use choke control whenever you are starting a cold engine. Do not use to start a warm engine.

•To engage choke control, pull knob out. Slowly push knob in to disengage.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents LGT2554 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Tools Required for AssemblyUnassembled Parts ToremovetractorfromcartonTo Adjust Seat See Fig To Install Mower and Drive Belt See FigsSET Parking Brake Lever and Lower AT- Tachment Lift See Fig Assemble Front Gauge Wheel W to Front of Mower See FigInstall ANTI-SWAY BAR S if Equipped See Slide Mower Under Tractor See FigANTI-SWAY BAR S Attach Mower Side Suspension Arms a to Chassis See Fig Attach Rear Lift Links C See FigAttach Front Link E See Fig Install Belt on Engine Clutch Pulley M See Check Tire PressureCheck Deck Levelness CheckforproperpositionofallbeltsOperation Know Your Tractor DPH AC JHOW to USE Your Tractor To SET Parking BRAKESee FigStopping See Fig To USE Throttle Control See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo Move Forward and Backward See Fig To Operate MowerService REMINDER/HOUR Meter Reverse Operation System ROS See FigTo Operate on Hills To Transport SeeBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Purge TransmissionMaintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning IN-LINE Fuel Filter See FigDeck Washout Port See Fig Service and Adjustments To Install MowerTo Remove Mower See Fig To Replace Mower Blade Drive Belt See FigTo Level Mower To Replace Motion Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER To Remove Wheel See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Start Engine with a Weak Battery See FigTo Attach Jumper Cables To Remove CABLES, Reverse OrderTransmission Storage OtherFuel System Engine OILProblem Cause Correction To run when oper Battery will notFires when turn Engine continuesDecals Wheels and TiresKEY Part Description Schematic SCH12Electrical KEY Part Description Chassis 532 40 873 90Drive 874 49 532 42Engine 30!2+ª!22%34%2ª+4Seat Assembly 532 42 SeatSteering Assembly 532 41 Wheel, Steering 532 19 Mower Deck 532 40 31-25 Deck Weldment Mower Mower Lift Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXLimitations and Exclusions HOW to Obtain Service Consumer Wheeled Warranty Chart 06.21.10 JA

532 43 00-01, 96045001502 specifications

The Husqvarna 96045001502,532 43 00-01 is an advanced lawn mower designed for homeowners seeking efficiency, durability, and exceptional cutting performance. This model stands out for its robust features and innovative technologies that make lawn maintenance a breeze.

One of the key features of the Husqvarna 96045001502 is its powerful engine. Equipped with a reliable and efficient gasoline engine, it delivers optimal performance and allows the mower to tackle various terrain types effortlessly. The engine is designed to provide consistent power, ensuring that the mower can handle thick grass and tough conditions without compromising on its cutting capability.

The cutting deck is another highlight of this model. The Husqvarna lawn mower boasts a wide cutting deck that ensures a clean and even cut across the lawn. This feature minimizes the number of passes needed to achieve a well-manicured appearance, saving valuable time while enhancing lawn aesthetics. Furthermore, the deck's design promotes efficient grass discharge, ensuring that clippings are evenly distributed across the lawn or can be easily collected for mulching purposes.

In terms of ergonomics, the Husqvarna 96045001502 is designed with user comfort in mind. The adjustable handlebar system allows users of different heights to find a comfortable grip, reducing fatigue during prolonged use. Additionally, the mower is lightweight yet sturdy, making it easy to maneuver around obstacles and navigate through tight spaces in the yard.

Safety is also a priority with this mower. It comes equipped with features such as automatic blade stop technology, which ensures the blades come to a halt instantly when the user releases the handle. This mechanism reduces the risk of accidents, making it a safe choice for families and inexperienced users alike.

The Husqvarna 96045001502,532 43 00-01 incorporates several innovative technologies that enhance its performance. The Air Injection system, for example, helps to keep the air filter clean longer by separating large debris from the airflow. This extends the life of the engine and maintains performance over time.

In summary, the Husqvarna 96045001502,532 43 00-01 is an exceptional lawn mower that combines power, efficiency, and user-friendly features. With its durable construction, ergonomic design, and advanced technologies, it stands out as a top choice for homeowners looking to maintain a beautiful, healthy lawn with ease.
Top Page Image Contents