Husqvarna 961430099 warranty Grass Catcher, Gear Case, To Change Engine OIL See Figs

Page 13

MAINTENANCE

GRASS CATCHER

The grass catcher may be hosed with water, but must be dry when used.

Check your grass catcher often for damage or dete- rioration. Through normal use it will wear. If catcher needs replacing, replace only with approved replace- ment catcher. Give the lawn mower model number when ordering.

GEAR CASE

To keep your drive system working properly, the gear case and area around the drive should be kept clean and free of trash build-up. Clean under the drive cover twice a season.

The gear case is filled with lubricant to the proper level at the factory. The only time the lubricant needs attention is if service has been performed on the gear case.

ENGINE

Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the custom- ers expense, may be performed by any non-road engine repair establishment or individual. Warranty repairs must be performed by an authorized engine manufacturer’s service outlet.

LUBRICATION

Use only high quality detergent oil rated with API service classification SG–SL. Select the oil's SAE viscosity grade according to your expected operating temperature.

NOTE: Multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, and you should check your engine oil level frequently to avoid possible engine damage from running low on oil.

Change the oil after every 25 hours of operation or at least once a year if the lawn mower is not used for 25 hours in one year.

Check the crankcase oil level before starting the engine and after each five (5) hours of continuous use. Tighten oil plug securely each time you check the oil level.

TO CHANGE ENGINE OIL (See Figs. 15 & 16)

NOTE: Before tipping lawn mower to drain oil, empty fuel tank by running engine until fuel tank is empty.

1.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

2.Remove oil fill cap/dipstick; lay aside on a clean surface.

3.Tip lawn mower on its side as shown and drain oil into a suitable container. Rock lawn mower back and forth to remove any oil trapped inside of engine.

CONTAINER

FIG. 15

4.Wipe off any spilled oil from lawn mower or side of engine.

5.Fill engine with oil. Slowly pour oil down the oil fill spout into the engine.

6.Wait one minute to allow oil to settle. Use guage on oil fill cap/dipstick for checking level. Insert dipstick into the tube and rest the oil fill cap on the tube. DO NOT thread the cap into the tube when taking reading.

OIL FILL CAP /

DIPSTICK

UPPER

MARK

LOWER

MARK

FIG. 16

7.Continue adding small amounts of oil and rechecking the dipstick until it reads full. DO NOT overfill, or engine will smoke on startup.

8.Always be sure to retighten oil fill cap/dipstick before starting engine.

9.Reconnect spark plug wire to spark plug.

AIR FILTER (See Fig. 17)

Your engine will not run properly and may be damaged by using a dirty air filter. Replace the air filter every 100 hours of operation or every season, whichever occurs first. Service air cleaner more often under dusty conditions.

TO CLEAN AIR FILTER

1.Remove cover.

2.Carefully remove cartridge.

3.Clean by gently tapping on a flat surface. If very dirty, replace cartridge.

13

Image 13
Contents Operator’s Manual Manuel de L’Opérateur Children Safety RulesII. General Operation Table of Contents Product Specifications AssemblyHOW to SET UP Your Lawn Mower Customer ResponsibilitiesTo Install Attachments Install Starter Rope See FigTo Assemble Grass Catcher See Fig Operation Meets Cpsc Safety RequirementsKnow Your Lawn Mower Engine Speed HOW to USE Your Lawn MowerEngine Zone Control To Convert Mower Simple Steps to Remember When Converting Your Lawn MowerBefore Starting Engine Mulching Mowing Tips Mowing TipsLubrication Chart MaintenanceGeneral Recommendations Before Each USETires Lawn MowerDrive Wheels Blade CareGrass Catcher EngineGear Case To Change Engine OIL See FigsClean Under Drive Cover CleaningWater Washout Feature See Fig MufflerTo Adjust Cutting Height Service and AdjustmentsRear Deflector Carburetor StorageHandle See Figs Other Troubleshooting PointsFuel System Engine OILPoor cut Consumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Consumer Wheeled Limited Warranty Chart Enfants Règles DE SécuritéII. Fonctionnement Général III. Fonctionnement Dans LES Pentes SommaireIV. Manipulation Sûre DU Carburant Entretien GénéraleSpécifications DE Produit MontageResponsabilités DU Client Pour Enlever LA Tondeuse À Gazon DU CartonInstaller LES Accessoires Installer LE Câble DE Démarreur Voir FigPour Monter LE RAMASSE-HERBE Voir Fig Connaissez SUR Votre Tondeuse À Gazon UtilisationRencontre LES Exigences DES Normes DE Sécurité Cpsc Commande D’ENTRAÎNEMENT Voir Fig Commande DE LA Vitesse DE MoteurRéglages DE LA Commande Contrôle DE LA Zone DU MoteurRamassage Arrière Voir Fig Pour Convertir LA TondeuseAvant DE Démarrer LE Moteur Conseils DE BROYER/TONDRE Conseils DE TondreEntretien Recommandations GénéralesTableau DE Lubrification Avant Chaque UtilisationRoues Motrices PneusEntretien DE LA Lame RAMASSE-HERBE MoteurBoîte DE Vitesse Lubrification DU MoteurSilencieux NettoyageBougie D’ALLUMAGE LE Dispositif DE Lavage DE L’EAU Voir FigPour Régler LA Hauteur DE Coupe Révision ET RéglagesDéflecteur Arrière Pour Enlever LA CourroieVitesse DE Moteur EntreposageCarburateur Guidon Voir les Figs etAutres Guide DE DépannageSystème D’ESSENCE Huile DE MoteurManque de AVERTISSEMENTS, Limitations ET Exclusions Comment Obtenir LE Service Location toute Location toute 02/18/2014 by