ENGLISH
Speaker connections
Protection circuit
The protection circuit is be activated in the following situations:
• If the speaker cable wire touches the rear panel or screws or if the |
Connecting recording components |
| Connecting a TV |
CD recorder / MD recorder | • Select the connector to use and connect the device. | |
• To listen to TV audio through this device, use the optical digital | ||
|
| connection. |
speaker cable wire touches the speaker cable’s + and – sides are |
touching |
• If the surrounding temperature is extremely high |
• If the inside of the amplifier gets hot to extended use at a high |
output |
If this happens, unplug the power cord, then check the connections of the speaker cables and input cables. If the unit becomes very hot, wait for it to cool off and improve the ventilation around it. After doing this, plug the power cord back in.
If the protection circuit is activated even though there are no problems with the ventilation around the unit or in connections, the unit may be damaged. Turn off the power and then contact a Marantz service center.
Cables used for connections
Audio cable (sold separately)
Stereo | (White) | L | L |
(Red) | R | R |
CD recorder /
MD recorder /
Tape deck
|
| AUDIO |
|
| IN | AUDIO |
|
| OUT | ||
L | R | L | R |
L | R | L | R |
L | R | L | R |
Cables used for connections
Audio cable (sold separately)
Stereo | (White) | L | L |
(Red) | R | R |
Optical cable
TV
AUDIO
AUDIO OPTICAL
OUT OUT
LR
L 
R
L 
R
NOTE
Other digital audio signals than 2 channel linear PCM cannot be input through AUX4 IN (OPTICAL) terminal of this unit.
When you try to input digital audio signals other than 2 channel linear PCM to this unit, set the digital audio output setting of the TV to 2 channel PCM.
For details, see the operating instructions of the TV.
6