Husqvarna 96045001500, 531 30 96-85, LGT2554 To Adjust Seat See Fig, To Install Mower See Figs

Page 6

ASSEMBLY

TO ADJUST SEAT (See Fig. 2):

•Grasp adjustment handle(A) and pull up, slide seat to desired position and release adjustment handle.

A

TO INSTALL MOWER (See Figs. 4-12)

Be sure tractor is on level surface and engage parking brake.

•Lower attachment lift lever to it's lowest position.

CAUTION: Lift lever is spring loaded. Have a tight grip on lift lever, lower it slowly and engage in lowest position.

•Turn steering wheel to the left as far as it will go and position mower on right side of tractor with deflector shield to the right.

Fig. 2

NOTE: You may now roll your tractor off the skid. Follow the instructions below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

•Raise attachment lift lever to its highest position.

•Releaseparkingbrakebydepressingclutch/brakepedal.

•Place freewheel control in "transmission disengaged" position (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

Continue with the instructions that follow.

ASSEMBLE FRONT WHEEL TO MOWER (See Fig. 3)

•Using shoulder bolt, washer and locknut from parts bag, assemble front wheel to mower as shown. Tighten securely.

Fig. 3

02965

Fig. 4

NOTE: Be sure mower side suspension arms (A) are pointing forward before sliding mower under tractor.

•Slide mower under tractor until it is centered under tractor.

A

Fig. 5

•FIRST INSTALL ANTI-SWAY BAR (S).

•From right side of mower, insert anti-sway bar into hole in transmission bracket (T).

 

T

S

 

 

 

A

 

6

 

Fig. 6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents LGT2554 General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope Operation III. Children Service General Service IV. TowingTable of Contents Unassembled Parts AssemblyTools Required for Assembly Before Removing Tractor from SkidFirst Install ANTI-SWAY BAR S To Adjust Seat See FigTo Install Mower See Figs Assemble Front Wheel to Mower See FigLB M Check Deck Levelness Mower Drive Belt InstallationCheck Tire Pressure Check for Proper Position of ALL BeltsOperation Know Your Tractor DPH AC JStopping See Fig HOW to USE Your TractorTo SET Parking BRAKESee Fig To USE Throttle Control See FigTo Move Forward and Backward See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerTo Transport See Service REMINDER/HOUR MeterUsing the Reverse Operation System To Operate on HillsADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Purge TransmissionMaintenance Lubrication ChartBlade Care BatteryTractor Blade Removal See FigEngine Cleaning To Remove Mower See Fig Service and AdjustmentsTo Install Mower To Level MowerTo Adjust Steering Wheel Alignment To Check BrakeFront Wheel TOE-IN/CAMBER Slide belt toward rear of tractor, off the steering plate To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig Remove from tractorTo Remove Wheel See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Start Engine with a Weak Battery See Fig To Attach Jumper CablesTransmission Fuel System StorageOther Engine OILProblem Cause Correction Fires when turn To run when operBattery will not Engine continuesKEY Part Description DecalsWheels and Tires 532 42Schematic SCH12Electrical KEY Part Description Chassis Chassis 532 19Drive Tractor Model NO. LGT2554 96045001500, Product no 45 Spark Arrester KIT EngineSeat Assembly 532 40 SeatSteering Assembly Tractor Model NO. LGT2554 96045001500, Product no 45 Mower Deck 532 40 31-25 Deck Weldment Mower Mower Lift Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXEffective January 1 Policy
Top Page Image Contents