CONTROLS
1. Ground Speed Lever
Located in the center of the console. Controls the forward speed of the mower. Push the lever forward if you want to go faster, pull it back to go slower or pull it all the way back to the stop postion.
To begin motion, the operator must move the ground speed lever forward before disengaging the neutral lock bail.
Ground Speed Lever Stop is the adjustment |
|
screw placed on the front edge of the console |
|
panel. It is used to insure ground speed lever |
|
does not over travel motion control levers into | |
| |
revese. | Ground Speed Lever |
2. Choke Control
The choke control is used for cold starts to provide the engine with a richer fuel mixture.
For cold starts the choke control should be pulled out.
Push the choke control gradually in when the engine is started till the engine runs smoothly.
Do not use the choke control when starting a warm engine.
Choke control
3. Ignition Switch
The ignition key switch is placed on the console panel and is also used to start the machine when it is equipped with an electric starter.
IMPORTANT INFORMATION
Do not run the starter for more than five seconds each time. If the engine does not start, wait about 10 seconds before re- trying.
Ignition key