LUBRICATION
3. Belt Adjuster, Mower Deck
Remove the plate (four screws) and lubricate with a grease gun, one zerk, until grease is forced out.
Use only good quality molybdenum disulphide grease.
Grease from
IMPORTANT INFORMATION
Be spartan and remove excess lubricant so that is does not come into contact with belts or belt pulley drive surfaces.
4. Outer belt wheels
Lubricate using a grease gun, one zerk, until the grease squeezes out. Lubricate on both sides.
Use only good quality molybdenum disulphide grease.
Grease from
5.Throttle and Choke Cables, Lever Bearings
Lubricate the cable ends at the carburetor with the oil can. Move the controls to the end points and lubricate again.
The throttle cable is also lubricated at the control when the control console is removed.
The belt adjuster grease zerk
Lubricating the outer belt wheels
Throttle and choke cables by the carburetor