Husqvarna YTH18542: Battery Replacement, Fuse Location, and Carburetor Adjustments
Page 23

SERVICE AND ADJUSTMENTS

REPLACING BATTERY (See Fig. 26)

WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connect- ing battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acci- dental grounding.

•Lift hood to raised position.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

•Connect BLACK grounding cable to negative (-) ter- minal with remaining hex bolt and keps nut. Tighten securely.

•Close hood.

HEX

KEPS

TERMINAL

BOLT

NUT

 

 

COVER

NEGATIVE

 

POSITIVE

(BLACK)

 

(RED)

CABLE

02747

CABLE

FIG. 26

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 27)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

02778

FIG. 27

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents 917.279060 II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceIII. Children Table of Contents Seat Unassembled PartsSteering Wheel Before Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills To Adjust Gauge Wheels See FigTo Operate Mower See Fig Reverse Operation System ROSADD Gasoline Before Starting the EngineTo Transport See Figs Check Engine OIL LevelAutomatic Transmission Warm UP Mowing TipsPurge Transmission Before Each USE MaintenanceLubrication Chart General RecommendationsCheck Operator Presence System TractorBlade Removal See Fig To Sharpen Blade See FigEngine Cleaning To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingBelt Removal Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See Fig To Check and Adjust BrakeTransaxle Motion Control Lever Neutral Adjustment See Fig See FigFront Wheel TOE-IN/CAMBER Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Points Engine dies when TRACTOR-MODEL Number YTH18542 917.279060, Product no 13 SchematicElectrical KEY Part NO. NO. Description Chassis TRACTOR-MODEL Number YTH18542 917.279060, Product no 13 Drive TRACTOR-MODEL Number YTH18542 917.279060, Product no 13 Steering Assembly TRACTOR-MODEL Number YTH18542 917.279060, Product no 13 Optional Equipment Engine1331 Mower LiftSeat Assembly Wheels and Tires DecalsMower Deck TRACTOR-MODEL Number YTH18542 917.279060, Product no 13 Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationWarranty Statement 532 19 58-63 Rev 3.18.05 RD
Related manuals
Manual 17 pages 30.7 Kb

YTH18542 specifications

The Husqvarna YTH18542 is a versatile and efficient lawn mower designed to meet the needs of homeowners looking for a reliable and high-performing machine for maintaining their lawns. Its robust design and advanced features make it a popular choice among gardening enthusiasts and professionals alike.

One of the standout features of the YTH18542 is its powerful 18.5 HP Briggs & Stratton engine. This engine provides ample power to tackle various lawn conditions, ensuring that grass cutting is smooth and efficient. The engine is designed for durability and ease of maintenance, allowing users to focus more on mowing and less on upkeep.

The YTH18542 is equipped with a 42-inch cutting deck that boasts a reinforced structure for added longevity. This cutting deck offers a variety of cutting heights, adjustable with a simple lever, which allows users to achieve their desired grass length easily. The wide cutting path minimizes mowing time while providing a clean, even cut.

In terms of comfort, the tractor features an ergonomic design with a comfortable seat, making longer mowing sessions less taxing. The easy-to-use steering wheel provides excellent maneuverability, allowing the operator to navigate tight corners and obstacles within the yard smoothly. Additionally, the implementation of a pedal-operated hydrostatic transmission ensures seamless speed control without the need for manual gear shifting.

Husqvarna's commitment to innovation is evident in the design of the YTH18542. The machine features a tight turning radius, which enhances agility and efficiency when working around flower beds, trees, and slopes. The mower also supports attachments, enabling users to expand its functionality with tools such as baggers or mulchers, making it a multi-season investment.

The mower includes safety features like an automatic blade engagement, which instantly starts the cutting blades only when the operator is seated. This promotes safety and reduces the risk of accidents.

Lastly, the YTH18542 possesses an aesthetically pleasing design, with a bright orange finish that is striking in any landscape. Its combination of performance, comfort, and safety features makes the Husqvarna YTH18542 a top choice for anyone seeking efficiency and quality in lawn care. With its dependable performance and innovative technologies, this mower is well-suited for various yard sizes and complexities.
Top Page Image Contents