Husqvarna YTH18K46 owner manual Before Starting the Engine, Check Engine OIL Level, ADD Gasoline

Page 12

OPERATION

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

Check engine oil with tractor on level ground.

Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32°F (0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP ENSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract mois- ture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

Be sure freewheel control is in the transmission engaged position.

Sit on seat in operating position, depress brake pedal and set parking brake.

Move attachment clutch to “DISENGAGED” position.

Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several at- tempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F/10° C and above)

When engine starts, move the throttle control to the fast position.

The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50° F/10° C and below)

When engine starts, allow engine to run with the throttle control in the choke position until the engine runs rough- ly, then move throttle control to fast position. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

Before driving the unit in cold weather, the transmission should be warmed up as follows:

Be sure the tractor is on level ground.

Release the parking brake and let the brake slowly return to operating position.

Allow one minute for transmission to warm up. This can be done during the engine warm up period.

The attachments can also be used during the engine warm-up period after the transmission has been warmed up.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32° F/0° C) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjust- ments section of this manual.

12

Image 12
Contents Operator’s Manual EnglishSafety Rules Safe Operation Practices for Ride-On MowersGeneral Service III. ChildrenSafe Handling of Gasoline Table of Contents Assembly Tools Required for AssemblyUnassembled Parts ToremovetractorfromcartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To SET Parking Brake See FigStopping See Fig To USE Throttle Control D See FigTo Operate Mower To Stop Mower BladesService REMINDER/HOUR Meter Using the Reverse Operation SystemReverse Operation System ROS See Fig To Operate on HillsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Purge TransmissionMaintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine BeltsTransaxle Cooling Transaxle Pump FluidCleaning Deck Washout Port See Fig Service and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G Visual SIDE-TO-SIDE Adjustment See Fig To Level MowerBelt Installation To Replace Mower Blade Drive Belt See FigTo Check Brake To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Replacing Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTransmission Storage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine continues Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXConsumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Consumer Wheeled Limited Warranty Chart 08/27/2012 BD

YTH18K46 specifications

The Husqvarna YTH18K46 is a robust and versatile riding lawn mower designed for homeowners seeking an efficient and reliable solution for maintaining their lawns. This compact tractor combines power, performance, and ease of use, making it an ideal choice for medium to large-sized yards.

One of the standout features of the YTH18K46 is its powerful 18-horsepower Kohler engine. This reliable engine ensures that users can tackle even the toughest mowing tasks with confidence. The engine is specifically designed for efficiency, providing an excellent balance of power and fuel economy, making it an environmentally friendly option as well.

The 46-inch cutting deck is another highlight of the YTH18K46. This wide deck allows for efficient mowing, covering more ground in less time. The cutting height can be easily adjusted from 1.5 to 4 inches, allowing homeowners to choose the perfect height for their grass. This versatility ensures that your lawn looks well-groomed, regardless of the season.

For added convenience, the YTH18K46 features an automatic choke system, making starting the mower easier without the hassle of manually adjusting choke settings. The pedal-operated hydrostatic transmission provides smooth and effortless speed control, allowing users to navigate their yards with precision.

The comfortable high-back seat, along with an ergonomic steering wheel, enhances the overall mowing experience. With added features such as a built-in cup holder and an easy-to-read fuel gauge, user comfort is prioritized during every mowing session.

Safety is also a key focus with the Husqvarna YTH18K46. It is equipped with an automatic blade engagement system that ensures the blades turn off when the operator leaves the seat, preventing accidents. Furthermore, the anti-scalp wheels on the cutting deck help prevent scalping of the turf, ensuring a clean and even cut.

In summary, the Husqvarna YTH18K46 is a powerful and practical riding mower that combines innovative technologies and thoughtful design. With its reliable engine, versatile cutting deck, and user-friendly features, it caters to the needs of homeowners looking for efficiency and comfort in lawn care. Whether you’re dealing with a sprawling lawn or navigating tight spaces, the YTH18K46 is built to deliver exceptional performance and results.