Husqvarna YTH18K46 owner manual Storage, Other, Fuel System, Engine OIL, Cylinders

Page 25

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

WARNING: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Mainte- nance section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Maintenance section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be dis- connected and battery cleaned thoroughly (See “TO CLEAN BATTERY AND TERMINALS” in the Mainte- nance section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Empty the fuel tank by starting the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in mini- mizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents English Operator’s ManualSafe Operation Practices for Ride-On Mowers Safety RulesIII. Children General ServiceSafe Handling of Gasoline Table of Contents Tools Required for Assembly AssemblyUnassembled Parts ToremovetractorfromcartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorStopping See Fig To USE Throttle Control D See FigTo Stop Mower Blades To Operate MowerUsing the Reverse Operation System Service REMINDER/HOUR MeterReverse Operation System ROS See Fig To Operate on HillsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigPurge Transmission Mowing TipsMaintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBlade Care Blade Removal See FigBelts EngineTransaxle Cooling Transaxle Pump FluidCleaning Deck Washout Port See Fig To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower Visual SIDE-TO-SIDE Adjustment See FigTo Replace Mower Blade Drive Belt See Fig Belt InstallationTo Check Brake To Replace Motion Drive Belt See FigReplacing Battery See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTransmission Other StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine continues Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationConsumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Consumer Wheeled Limited Warranty Chart 08/27/2012 BD

YTH18K46 specifications

The Husqvarna YTH18K46 is a robust and versatile riding lawn mower designed for homeowners seeking an efficient and reliable solution for maintaining their lawns. This compact tractor combines power, performance, and ease of use, making it an ideal choice for medium to large-sized yards.

One of the standout features of the YTH18K46 is its powerful 18-horsepower Kohler engine. This reliable engine ensures that users can tackle even the toughest mowing tasks with confidence. The engine is specifically designed for efficiency, providing an excellent balance of power and fuel economy, making it an environmentally friendly option as well.

The 46-inch cutting deck is another highlight of the YTH18K46. This wide deck allows for efficient mowing, covering more ground in less time. The cutting height can be easily adjusted from 1.5 to 4 inches, allowing homeowners to choose the perfect height for their grass. This versatility ensures that your lawn looks well-groomed, regardless of the season.

For added convenience, the YTH18K46 features an automatic choke system, making starting the mower easier without the hassle of manually adjusting choke settings. The pedal-operated hydrostatic transmission provides smooth and effortless speed control, allowing users to navigate their yards with precision.

The comfortable high-back seat, along with an ergonomic steering wheel, enhances the overall mowing experience. With added features such as a built-in cup holder and an easy-to-read fuel gauge, user comfort is prioritized during every mowing session.

Safety is also a key focus with the Husqvarna YTH18K46. It is equipped with an automatic blade engagement system that ensures the blades turn off when the operator leaves the seat, preventing accidents. Furthermore, the anti-scalp wheels on the cutting deck help prevent scalping of the turf, ensuring a clean and even cut.

In summary, the Husqvarna YTH18K46 is a powerful and practical riding mower that combines innovative technologies and thoughtful design. With its reliable engine, versatile cutting deck, and user-friendly features, it caters to the needs of homeowners looking for efficiency and comfort in lawn care. Whether you’re dealing with a sprawling lawn or navigating tight spaces, the YTH18K46 is built to deliver exceptional performance and results.
Top Page Image Contents