Husqvarna YTH18K46 owner manual To Level Mower, Visual SIDE-TO-SIDE Adjustment See Fig

Page 21

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER

Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 27)

•With all tires properly inflated and if your lawn appears unevenly cut, determine which side of mower is cutting lower.

•With a 3/4" or adjustable wrench, turn lift link adjust- ment nut (A) to the left to lower LH side of mower, or, to the right to raise LH side of mower.

 

A

Turn nut right

Turn nut left

to raise mower

to lower mower

02948

 

Fig. 27

NOTE: Each full turn of adjustment nut will change mower height about 3/16".

•Test your adjustment by mowing some uncut grass and visually checking the appearance. Readjust, if necessary, until you are satisfied with the results.

PRECISION SIDE-TO-SIDE ADJUSTMENT (See Fig. 28)

•With all tires properly inflated, park tractor on level ground or driveway.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

•Raise mower to its highest position.

•At both sides of mower, position blade at side and measure the distance (A) from bottom edge of blade to the ground. The distance should be the same on both sides.

 

02966

A

A

Fig. 28

•If adjustment is necessary, see step in Visual Adjust- ment instructions above.

•Recheck measurements, adjust if necessary until both sides are equal.

FRONT-TO-BACK ADJUSTMENT (See Figs. 29 & 30) IMPORTANT: Deck must be level side-to-side.

To obtain the best cutting results, the mower blades should be adjusted so the front tip is 1/8" to 1/2" lower than the rear tip when the mower is in its highest position.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

•Raise mower to highest position.

•Position any blade so the tip is pointing straight forward. Measure distance (B) to the ground at front and rear tip of the blade.

02548

BB

Fig. 29

•If front tip of blade is not 1/8" to 1/2" lower than the rear tip, go to the front of tractor.

•With an 11/16" or adjustable wrench, loosen jam nut A several turns to clear adjustment nut B.

•With a 3/4" or adjustable wrench, turn front link adjust- ment nut (B) clockwise (ltighten) to raise the front of mower, or, counterclockwise (loosen) to lower the front mower.

B

A

TIGHTEN ADJUST

LOOSEN

ADJUST NUT

NUT B TO RAISE

B TO LOWER

MOWER

 

02950

MOWER

 

 

LOOSEN JAM NUT A FIRST

 

Fig. 30

NOTE: Each full turn of the adjustment nut will change mower height about 1/8".

•Recheck measurements, adjust if necessary until front tip of blade is 1/8" to 1/2" lower than the rear tip.

•Hold adjustment nut in position with wrench and tighten jam nut securely against adjustment nut.

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents English Operator’s ManualSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Service III. ChildrenSafe Handling of Gasoline Table of Contents Tools Required for Assembly AssemblyUnassembled Parts ToremovetractorfromcartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorStopping See Fig To USE Throttle Control D See FigTo Stop Mower Blades To Operate MowerUsing the Reverse Operation System Service REMINDER/HOUR MeterReverse Operation System ROS See Fig To Operate on HillsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigPurge Transmission Mowing TipsMaintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBlade Care Blade Removal See FigBelts EngineTransaxle Cooling Transaxle Pump FluidCleaning Deck Washout Port See Fig Service and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower Visual SIDE-TO-SIDE Adjustment See FigTo Replace Mower Blade Drive Belt See Fig Belt InstallationTo Check Brake To Replace Motion Drive Belt See FigReplacing Battery See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTransmission Other StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine continues Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationConsumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Consumer Wheeled Limited Warranty Chart 08/27/2012 BD

YTH18K46 specifications

The Husqvarna YTH18K46 is a robust and versatile riding lawn mower designed for homeowners seeking an efficient and reliable solution for maintaining their lawns. This compact tractor combines power, performance, and ease of use, making it an ideal choice for medium to large-sized yards.

One of the standout features of the YTH18K46 is its powerful 18-horsepower Kohler engine. This reliable engine ensures that users can tackle even the toughest mowing tasks with confidence. The engine is specifically designed for efficiency, providing an excellent balance of power and fuel economy, making it an environmentally friendly option as well.

The 46-inch cutting deck is another highlight of the YTH18K46. This wide deck allows for efficient mowing, covering more ground in less time. The cutting height can be easily adjusted from 1.5 to 4 inches, allowing homeowners to choose the perfect height for their grass. This versatility ensures that your lawn looks well-groomed, regardless of the season.

For added convenience, the YTH18K46 features an automatic choke system, making starting the mower easier without the hassle of manually adjusting choke settings. The pedal-operated hydrostatic transmission provides smooth and effortless speed control, allowing users to navigate their yards with precision.

The comfortable high-back seat, along with an ergonomic steering wheel, enhances the overall mowing experience. With added features such as a built-in cup holder and an easy-to-read fuel gauge, user comfort is prioritized during every mowing session.

Safety is also a key focus with the Husqvarna YTH18K46. It is equipped with an automatic blade engagement system that ensures the blades turn off when the operator leaves the seat, preventing accidents. Furthermore, the anti-scalp wheels on the cutting deck help prevent scalping of the turf, ensuring a clean and even cut.

In summary, the Husqvarna YTH18K46 is a powerful and practical riding mower that combines innovative technologies and thoughtful design. With its reliable engine, versatile cutting deck, and user-friendly features, it caters to the needs of homeowners looking for efficiency and comfort in lawn care. Whether you’re dealing with a sprawling lawn or navigating tight spaces, the YTH18K46 is built to deliver exceptional performance and results.
Top Page Image Contents