Husqvarna YTH18K46 owner manual Tractor, Blade Care, Blade Removal See Fig, Battery

Page 15

MAINTENANCE

TRACTOR

Always observe safety rules when performing any maintenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted. (See “TO CHECK BRAKE” in the Service and Adjustments section of this manual).

TIRES

•Maintain proper air pressure in all tires (See the sides of tires for proper PSI).

•Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OPERATION SYSTEM (ROS) (See Fig. 14)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never operate unless the operator is in the seat.

CHECK REVERSE OPERATION (ROS) SYSTEM

•When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

 

 

 

 

 

 

 

 

 

 

02828

ROS "ON"

ENGINE "ON" POSITION

POSITION

(NORMAL OPERATING)

 

 

 

 

 

 

Fig. 14

BLADE CARE

For best results mower blades must be kept sharp. Replace bent or damaged blades.

CAUTION: Use only a replacement blade ap- proved by the manufacturer of your tractor. Using a blade not approved by the manu- facturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 15)

•Raise mower to highest position to allow access to blades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

•Remove blade bolt by turning counterclockwise.

•Install new or resharpened blade with stamped "THIS SIDE UP" facing deck and mandrel assembly.

IMPORTANT: To ensure proper assembly, center hole in blade must align with star on mandrel assembly.

•Install and tighten blade bolt securely (45-55 Ft. Lbs./62-75Nm).

IMPORTANT: SPECIAL BLADE BOLT HEAT TREATED.

MANDREL ASSEMBLY

 

BLADE

 

BLADE BOLT

STAR

(SPECIAL)

CENTER HOLE

Fig. 15

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour.

NOTE:Theoriginalequipmentbatteryonyourtractorismain- tenance free. Do not attempt to open or remove caps or cov- ers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

•Remove terminal guard.

•Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor.

•Rinse the battery with plain water and dry.

•Clean terminals and battery cable ends with wire brush until bright.

•Coat terminals with grease or petroleum jelly.

•Reinstall battery (See “REPLACING BATTERY" in the Service and Adjustments section of this manual).

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents English Operator’s ManualSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Service III. ChildrenSafe Handling of Gasoline Table of Contents Toremovetractorfromcarton AssemblyTools Required for Assembly Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo Stop Mower Blades To Operate MowerTo Operate on Hills Service REMINDER/HOUR MeterUsing the Reverse Operation System Reverse Operation System ROS See FigTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolinePurge Transmission Mowing TipsSchedule MaintenanceMaintenance General RecommendationsBlade Removal See Fig BatteryTractor Blade CareTransaxle Pump Fluid EngineBelts Transaxle CoolingCleaning Deck Washout Port See Fig Service and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower Visual SIDE-TO-SIDE Adjustment See FigTo Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigReplacing Battery See Fig Front Wheel TOE-IN/CAMBERTransmission Engine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine continues Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationConsumer Wheeled Products Limited Warranty HOW to Obtain Service Consumer Wheeled Limited Warranty Chart Consumer Wheeled Limited Warranty Chart 08/27/2012 BD

YTH18K46 specifications

The Husqvarna YTH18K46 is a robust and versatile riding lawn mower designed for homeowners seeking an efficient and reliable solution for maintaining their lawns. This compact tractor combines power, performance, and ease of use, making it an ideal choice for medium to large-sized yards.

One of the standout features of the YTH18K46 is its powerful 18-horsepower Kohler engine. This reliable engine ensures that users can tackle even the toughest mowing tasks with confidence. The engine is specifically designed for efficiency, providing an excellent balance of power and fuel economy, making it an environmentally friendly option as well.

The 46-inch cutting deck is another highlight of the YTH18K46. This wide deck allows for efficient mowing, covering more ground in less time. The cutting height can be easily adjusted from 1.5 to 4 inches, allowing homeowners to choose the perfect height for their grass. This versatility ensures that your lawn looks well-groomed, regardless of the season.

For added convenience, the YTH18K46 features an automatic choke system, making starting the mower easier without the hassle of manually adjusting choke settings. The pedal-operated hydrostatic transmission provides smooth and effortless speed control, allowing users to navigate their yards with precision.

The comfortable high-back seat, along with an ergonomic steering wheel, enhances the overall mowing experience. With added features such as a built-in cup holder and an easy-to-read fuel gauge, user comfort is prioritized during every mowing session.

Safety is also a key focus with the Husqvarna YTH18K46. It is equipped with an automatic blade engagement system that ensures the blades turn off when the operator leaves the seat, preventing accidents. Furthermore, the anti-scalp wheels on the cutting deck help prevent scalping of the turf, ensuring a clean and even cut.

In summary, the Husqvarna YTH18K46 is a powerful and practical riding mower that combines innovative technologies and thoughtful design. With its reliable engine, versatile cutting deck, and user-friendly features, it caters to the needs of homeowners looking for efficiency and comfort in lawn care. Whether you’re dealing with a sprawling lawn or navigating tight spaces, the YTH18K46 is built to deliver exceptional performance and results.
Top Page Image Contents