| CONTROLS | |
Tracking Knob |
| |
If the mower is not tracking straight, check the |
| |
air pressure in both rear tires. Recommended air |
| |
pressure for the rear tires is 15 psi (1 bar). |
| |
1. | Tracking adjustments are made using the tracking |
|
| bolt and tracking knob. The tracking bolt and |
|
| tracking knob act as limiting devices for the |
|
| motion control levers when in the |
|
| position. |
|
2. | For preliminary tracking adjustment, move unit |
|
| to an open, unobstructed area such as an empty |
|
| parking lot or open field. |
|
3. | Back the tracking bolt out until flush with nut. |
|
4. | Loosen tracking knob out until flush with nut. |
|
5. | Test operate unit by driving it at full throttle and | |
| the full forward position on both motion control | Tracking adjustment |
| levers. Gradually turn in the tracking bolt on the |
|
| right hand side until the unit noticeably starts |
|
| drifting right. |
|
6.Drive forward at full throttle with both motion control levers in the full forward position. Gradually turn in the tracking knob (left side) until unit tracks straight.
Parking Brake
The parking brake is found on the left of the machine. Pull the lever backward to activate the brake and push forward to release it.
IMPORTANT INFORMATION
The machine must stand absolutely still when applying the parking brake. Always set the parking brake before dismounting. Release the parking brake before moving the mower.
Parking brake
20