OPERATION
6.Move the steering controls outward to the locked (outer) neutral position.
7. Move the throttle to the middle position.
8.Turn the key to the RUN position and wait for the glow plug light to go out. Press in and turn the ignition key to the START position.
If the engine fails to start after 10 seconds, the engine will stop cranking and the ignition switch must be turned off to reset the start sequence. When the engine starts, immediately release the ignition key back to the run position.
NOTE: The fan will power up thirty seconds after the ignition is turned on and will blow air through the radiator to help clean debris from the radiator and debris screen. The fan will then reverse and continue in suction until the ignition is turned off.
Place controls in neutral position
Set the throttle
Turn the key to RUN and observe glow plug light
30