Husqvarna YTH1342XP owner manual Before Starting the Engine, Check Engine OIL Level, ADD Gasoline

Page 13

OPERATION

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

•The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Unthread and remove oil fill cap/dipstick; wipe oil off. Reinsert the dipstick into the tube and rest oil fill cap on the tube. Do not thread the cap onto the tube. Remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see theMaintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during stor- age. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or car- buretor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 6)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place motion control lever in neutral (N) position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to fast position

•Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50° F and below)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the engine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Place the motion control lever in neutral. Release the parking brake and let the clutch/

brake slowly return to operating position.

•Allow one minute for transmission to warm up.This can be done during the engine warm up period.

•The attachments can be used during the engine warm- up period after the transmission has been warmed up and may require the choke control be pulled out slightly.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

PURGE TRANSMISSION

CAUTION: Never engage or disengage freewheel lever while the engine is run- ning.

To ensure proper operation and performance, it is recom- mended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have de- veloped during shipping of your tractor.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents YTH1342XP IV. Service Safety RulesGeneral Operation II. Slope OperationSafety Rules Table of Contents Steering Wheel Seat Unassembled PartsBlade KeyTools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidTo SET UP Your Mower for Mulching Install Seat See FigCheck Tire Pressure To Convert to Bagging or DischargingCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig To Adjust Gauge Wheels See FigTo Operate on Hills To Transport See FigsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigMulching Mowing Tips Mowing TipsLubrication Chart MaintenanceService Dates General RecommendationsTractor Engine Muffler CleaningSpark Plugs Engine OIL FilterTo Install Mower See Fig Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal Transmission REMOVAL/REPLACEMENT To Check and Adjust Brake See FigTransaxle Motion Control Lever Neutral ADJUSTMENTSee Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig To Adjust Steering Wheel AlignmentFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Carburetor To Adjust Throttle Control CableTo Replace Headlight Bulb Interlocks and RelaysOther StorageFuel System Engine OILTroubleshooting Points OFF Tractor Model NO. YTH1342XP YTH1342XPA, Product no 56 SchematicElectrical KEY Part Description Chassis and Enclosures 532 18 Drive Repair Parts Steering Assembly 532 18 Wheel Steering 532 18 Seat Seat Assembly532 17 DecalsEngine Repair PartsMower Lift Mower Deck 532 17 Belt Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationWarranty Statement 532 18 44-43 Rev 03.20.03 RH/MH/RH/TR

YTH1342XP specifications

The Husqvarna YTH1342XP is a reliable and efficient riding lawn mower that caters to the needs of homeowners with medium to large-sized lawns. This advanced mower model brings together a robust construction, modern technologies, and user-friendly features, creating an exceptional mowing experience.

At the heart of the YTH1342XP is its powerful 13.5 HP Kohler engine, providing ample power to handle tough grass conditions with ease. The engine is designed for durability and longevity, ensuring that it can withstand regular use season after season. With a hydrostatic transmission, the mower offers smooth and effortless speed adjustments, allowing users to navigate different terrains without experiencing bumps or transitions.

The YTH1342XP features a 42-inch cutting deck that provides effective coverage and makes mowing faster and more efficient. The deck is constructed from high-quality materials, ensuring longevity and resistance to wear and tear. It also has a reinforced cutting deck that enables the mower to tackle taller grass and dense underbrush.

One of the standout characteristics of the YTH1342XP is its cutting height adjustment, which allows users to select from multiple cutting heights based on the specific needs of their lawn. This flexibility ensures a precise and professional-looking finish, which is particularly valuable for lawn enthusiasts.

To enhance user comfort, the mower is equipped with a comfortable high-back seat and ergonomic steering, making long mowing sessions less tiresome. The easy-to-use dashboard includes intuitive controls that make starting the mower and adjusting settings simple.

The YTH1342XP is also compatible with several accessories, including baggers and mulch kits, which can be added to enhance the mower’s functionality. Furthermore, Husqvarna has engineered this model with advanced safety features, including an automatic shut-off function that engages when the driver leaves the seat.

In summary, the Husqvarna YTH1342XP is a robust riding mower that stands out for its powerful performance, versatile cutting options, and thoughtful design elements aimed at improving user experience. Whether maintaining a small yard or managing a larger lawn, this mower offers the efficiency, durability, and comfort that discerning homeowners demand.
Top Page Image Contents