ASSEMBLY
Fitting the handlebar
Lift up the handlebar until the handlebar's upper tubular construction comes directly opposite to the handlebar's lower section. Tighten the knob correctly.
Take care not to damage the cables and wires when you fold up the handlebar.
Dismantling and assembling the cutter
WARNING! Always wear
!when servicing and maintaining the cutting equipment. The cutters are very sharp and cuts can occur very easily.
The ignition lead should always be removed from the spark plug before repair, cleaning or maintenance work.
Always empty the fuel tank before you place the lawn mower on its side.
Dismantling
•Unscrew the bolt holding the cutter.
•Remove bolt, washer and cup spring.
•Remove the cutter.
Assembly
•Position the cutter so that the cutting edge faces in the direction of rotation.
•Fit the cup spring, make sure it centres correctly on the engine shaft.
•Fit the washer and tighten the bolt correctly. The bolt should be tightened with a torque of
12 – English