Husqvarna M48 Pro, M53 S manual Fuel Handling, Petrol, Engine oil, Fuelling

Page 13

FUEL HANDLING

Fuel

WARNING! Always ensure there is adequate

!ventilation when handling fuel.

Petrol

Use good quality unleaded petrol. Leaded petrol can be used if unleaded petrol is not available.

Fuel should be at least 77 octane.

If the machine is not used for some time the fuel tank should be emptied and cleaned.

Engine oil

Check the oil level before starting the lawn mower. A too low oil level can cause serious damage to the engine.

For the best result and function use HUSQVARNA four- stroke oil.

If HUSQVARNA four-stroke oil is not available, you may use another four-stroke oil of good quality. Contact your dealer when selecting oil. In general SAE 30 is recommended.

Never use oil intended for two-stroke engines.

Check the oil level before starting the lawn mower. A too low oil level can cause serious damage to the engine.

Oil level

The lawn mower should stand on flat ground when you check the oil level. Ensure the ignition lead has been removed from the spark plug before you open the oil filler cap.

Unscrew the oil filler cap and check the oil level on the dipstick fitted to the cover.

The oil filler cap must be completely screwed down to give a correct picture of the oil level.

If the oil level is low, fill using engine oil up to the upper level on the dipstick.

FILL

VER

O

T

NO

O

D

ION

CAUT

FULL

Only use recommended engine oil. See the Technical data section.

Fuelling

WARNING! Taking the following precautions,

!

will lessen the risk of fire:

 

Do not smoke or place hot objects near fuel.

Always shut off the engine before refuelling.

When refuelling, open the fuel cap slowly so that any excess pressure is released gently.

Tighten the fuel cap carefully after refuelling.

Always move the machine away from the refuelling area before starting.

Always remove the ignition lead from the spark plug before refuelling.

Do not fill too much petrol. Leave about 35 mm under the filler cap so that the fuel can expand.

Clean around the fuel cap. Clean the fuel and oil tank regularly. The fuel filter should be changed at least once a year. Contamination in the tanks causes malfunction.

Always move the machine about 3 metres from the refuelling position before starting.

English – 13

Image 13
Contents English M48 M53 SKey to symbols KEY to SymbolsSteps before using a new lawn mower Contents Machine′s safety equipment Safety InstructionsPersonal protection Cutting cover and protective coverMuffler Vibration damping systemChecking the cutting cover and protective cover Checking the brake triggerCutting equipment General safety precautionsIncrease the risk of accidents Starting Fuel safetyTransport and storage Before useGeneral working instructions Basic safety rulesBasic mowing technique GeneralCutting height Adjusting the cutting heightWhat is what on the lawn mower? M48 What is WHAT?What is what on the lawn mower? M53 S Assembly AssemblyFitting the handlebar Dismantling and assembling the cutterFuel Fuel HandlingPetrol Engine oilStarting and stopping Starting and StoppingMaintenance MaintenanceCleaning the air filter Air filterMuffler Spark plugCutter Changing the oilDrive and gearbox Lubrication of the cutting height adjustmentM48 M53 S Weekly maintenance Daily maintenanceMonthly maintenance Below you will find some general maintenance instructionsTechnical data Technical DataEC-declaration of conformity Applies to Europe only1140250-26 ´z+H9¶6P¨ ´z+H9¶6P¨