Husqvarna MZ61 warranty Transport, Spark Arrestor

Page 16

SAFETY

Transport

The machine is heavy and can cause serious crushing injuries. Be extra cautious when it is loaded on or unloaded from a vehicle or trailer.

Use an approved trailer to transport the machine. Activate the parking brake, turn off the fuel supply, and fasten the machine with approved fastening devices, such as bands, chains, or straps, when transporting.

Do not operate this machine on public roadways.

Check and abide by local traffic regulations before transporting the machine on any road.

Do not tow this machine: it may cause damage to the drive system.

Load the unit onto truck or trailer by driving up ramps of suitable strength using a slow speed. Do not lift! The machine is not intended to be lifted by hand.

When loading or unloading this machine, do not exceed the maximum recommended operation angle of 10O.

Towing

If machine is equipped with a tow hitch, use extreme caution when towing. Never allow children or others in or on towed equipment..

Make wide turns to avoid jack-knifing. Travel slowly and allow extra distance to stop. Do not tow on sloped ground. The weight of the towed equipment may cause loss of traction and loss of control.

Follow the manufacturer’s recommendation for weight limits for towed equipment. Do not tow near ditches, canals, and other hazards.

Spark Arrestor

This mower is equipped with an internal combustion engine and should not be used on or near any unimproved forested, bush covered or grassy lands unless the engine’s system is equipped with a spark arrestor meeting applicable local or state laws (if any).

In the state of California the above is required by law (Section 4442 of the California Public Resources Code).

Other states may have similar laws. Federal laws apply on federal lands.

A spark arrestor for the muffler is available through any authorized Husqvarna dealer.

WARNING! Use extreme caution when loading the machine into a truck or trailer using ramps. There is the possibility of serious injury or death if the machine falls off the ramps.

IMPORTANT INFORMATION

The parking brake is not sufficient to lock the machine in place during transport. Ensure that the machine is well fastened to the transport vehicle. Always reverse the machine onto the transport vehicle to avoid tipping it over.

WARNING! Escaping hydraulic oil under pressure can have sufficient force to penetrate the skin, causing serious injury. If injured by escaping fluid, see a doctor at once. Serious infection or reaction can develop if proper medical treatment is not administered immediately.

WARNING! This mower is equipped with an internal combustion engine and should not be used on or near any unimproved forested, bush covered or grassy lands unless the engine's system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrestor is used, it should be maintained in effective working order by the operator.

16

Image 16
Contents Operator Manual All rights reserved Contents Page Introduction Good Service Manufacturing NumberSymbols and Decals Xxxxxxxxx xxxxxx xxxxxxxxx. xx xxxxxxxx xxxxRemove key before Performing any Safety Instructions SafetyGeneral Operation Never take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Use protective glasses for maintenance workRisk of sparking Transport Spark ArrestorControls Control LocationsMotion Control Levers Blade Switch Service MinderChoke Control Ignition Switch Parking Brake Tracking KnobFuses Seat Adjustment Lever Cutting Height AdjusterFuel Shut Off Valve Fuel Tank Hydro Release LeversTraining OperationSteering Before Starting Starting the Engine Place controls in neutral position Press in and turn the ignition key to the start position Weak Battery To remove cables, reverse orderRunning Operating on Hills Stopping the Engine Mowing Tips Moving Machine By Hand Engine stopped Ignition key removed Parking brake activatedMaintenance Maintenance ScheduleMaintenance Battery Replacing batterySafety System Tire PressuresDeck Belt Deck Belt InstallationDeck Belt Removal Belt Installation Pump BeltBelts Replacing Pump BeltCutting Blades Adjusting the Mower Deck Leveling deckAnti-scalp rollers Cleaning Use protective glasses when cleaning and washingCaster Wheels HardwareLubrication Schedule LubricationGeneral Wheel and Deck Zerks Front Wheel MountFront Wheel Bearings Deck SpindlesEngine oil change Transaxle Transmission Fluid ChangeTransmission Purging Troubleshooting Guide Problem CauseTroubleshooting Guide Storage ServiceWinter Storage Schematic Technical Data Torque SpecificationsStandard Hardware Metric Standard HardwareBriggs & Stratton Conformity Certificates USA requirementsService Journal Delivery ServiceAction Stamp, signAfter 10 hours Date, mtr reading Stamp, signDaily Service Hour Service Service Journal Service Journal At least once each year Page 115 647127 Rev a 2013-10-01