Husqvarna Zero Turn Fuse Location, MZ61 Problems, and Manual

Page 21

CONTROLS

Tracking Knob

If the mower is not tracking straight, check the air pressure in both rear tires. Recommended air pressure is 15 psi (1 bar) for all tires. Tracking must be checked on a flat and level concrete or blacktop surface.

Rotating the tracking knob allows fine tuning adjustments so the machine tracks straight with the steering control levers in the full forward position.

Rotate the knob clockwise (as viewed from the operation position) to increase the speed on the left lever. Rotate counterclockwise to decrease speed.

Parking Brake

The parking brake is found on the left of the machine. Pull the lever backward to activate the brake and push forward to release it.

IMPORTANT INFORMATION

The machine must stand absolutely still when applying the parking brake. Always set the parking brake before dismounting. Release the parking brake before moving the mower.

Fuses

Fuses are located on the left hand side of the machine. They are accessed by tilting the seat forward. Fuses are flat pin fuses type as used in automobiles.

There are two fuses with ratings and functions:

20 A, Primary fuse

7.5 A, Mower deck coupling

8058-182

Tracking knob

8058-182

Parking brake

8050-082

Fuses

21

Image 21
Contents Operator Manual All rights reserved Contents Page Introduction Manufacturing Number Good ServiceXxxxxxxxx xxxxxx xxxxxxxxx. xx xxxxxxxx xxxx Symbols and DecalsRemove key before Performing any Safety Safety InstructionsGeneral Operation Never take passengers Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline Use protective glasses for maintenance work General MaintenanceRisk of sparking Spark Arrestor TransportControl Locations ControlsMotion Control Levers Service Minder Blade SwitchChoke Control Ignition Switch Tracking Knob Parking BrakeFuses Cutting Height Adjuster Seat Adjustment LeverFuel Shut Off Valve Hydro Release Levers Fuel TankOperation TrainingSteering Before Starting Starting the Engine Place controls in neutral position Press in and turn the ignition key to the start position To remove cables, reverse order Weak BatteryRunning Operating on Hills Stopping the Engine Mowing Tips Engine stopped Ignition key removed Parking brake activated Moving Machine By HandMaintenance Schedule MaintenanceMaintenance Replacing battery BatteryTire Pressures Safety SystemDeck Belt Installation Deck BeltDeck Belt Removal Pump Belt Belt InstallationBelts Replacing Pump BeltCutting Blades Leveling deck Adjusting the Mower DeckAnti-scalp rollers Use protective glasses when cleaning and washing CleaningCaster Wheels HardwareLubrication Lubrication ScheduleGeneral Front Wheel Mount Wheel and Deck ZerksFront Wheel Bearings Deck SpindlesTransaxle Transmission Fluid Change Engine oil changeTransmission Purging Problem Cause Troubleshooting GuideTroubleshooting Guide Service StorageWinter Storage Schematic Torque Specifications Technical DataStandard Hardware Metric Standard HardwareBriggs & Stratton USA requirements Conformity CertificatesDelivery Service Service JournalAction Stamp, signDate, mtr reading Stamp, sign After 10 hoursDaily Service Hour Service Service Journal Service Journal At least once each year Page 115 647127 Rev a 2013-10-01