Husqvarna 2348 LS Before Starting the Engine, Service REMINDER/HOUR Meter, Check Engine OIL Level

Page 12

OPERATION

SERVICE REMINDER/HOUR METER

Service reminder shows the total number of hours the engine has run and flashes to indicate that the engine or mower needs servicing. When service is required, the service reminder will flash for two hours. To service engine and mower, see the Maintenance section of this manual.

NOTE: Service reminder runs when the ignition key is in any position but "STOP". For accurate reading, be sure key remains in the "STOP" position when engine is not running.

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

12

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress brake pedal and set parking brake.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

•When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast posi- tion. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Release the parking brake and let the brake slowly return to operating position.

•Allow one minute for transmission to warm up. This can be done during the engine warm up period.

•The attachments can also be used during the engine warm-up period after the transmission has been warmed up.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

Page 11 Page 13
Image 12
Page 11 Page 13
Contents 2348 LS Safety Rules Safe Operation Practices for Ride-On MowersII. Slope Operation General OperationService III. ChildrenIV. Towing Table of Contents Assembly Unassembled PartsTo Remove Tractor from Carton Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To SET Parking BRAKESee aStopping See b To USE Throttle Control D SeeTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigSystem Characteristics To Move Forward and Backward See FigUsing the Reverse Operation System To Operate Mower See FigReverse Operation System ROS To Operate on HillsService REMINDER/HOUR Meter Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionMaintenance Lubrication ChartTractor Brake OperationTires Blade CareEngine Cleaning Service and Adjustments To Install Mower See FigsTo Remove Mower See Fig First Install ANTI-SWAY BAR S Engage belt tension rod K on locking bracket L To Level Mower Mower Drive Belt Installation To Replace Mower Blade Drive BeltMower Drive Belt Removal Belt Installation To Replace Motion Drive Belt See FigBelt Removal To Start Engine with a Weak Battery See Fig To Check BrakeFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Engine dies when Schematic SCH12Electrical KEY Part Description Chassis Tractor - Model Number 2348LS 96043004400, Product no 43 Drive 197 196532 40 53-84 Transaxle, Tufftorq K46 171 872 11 Spark Arrester KIT Engine211 6962 8179 Engine Power Rating Information Steering Assembly 532 41 Wheel, Steering 532 19 Seat Assembly 532 40 SeatDecals Wheels and TiresMower Deck 532 41 87-00 Deck Weldment Mower Mower Lift Warranty Statement Suggested Guide for Sighting Slopes for Safe Operation Service Notes Service Notes 532 41 84-82 12.01.07 TH

2348 LS specifications

The Husqvarna 2348 LS is a powerful and versatile riding lawn mower designed to meet the needs of homeowners looking for a reliable machine for their lawn care routine. Known for its robust features and ease of use, it combines functionality and comfort, making it an excellent choice for residential use.

One of the standout features of the Husqvarna 2348 LS is its powerful 24 HP Briggs & Stratton engine, which provides the necessary power to tackle tough mowing tasks efficiently. This engine is designed for optimal performance and reliability, ensuring that users can mow their lawns with confidence. The automatic transmission allows for smooth acceleration and gear shifting without the need for manual intervention, making it user-friendly for individuals of all skill levels.

The cutting deck is another critical element of the 2348 LS model. With a 48-inch cutting width, it provides an impressive mowing area that reduces the time spent mowing. The cutting height can be easily adjusted, enabling users to customize the height according to their lawn's needs. This flexibility ensures that the grass is cut evenly and maintains a healthy appearance.

The Husqvarna 2348 LS is equipped with advanced features, such as the clearcut deck design, which enhances the mowing efficiency and gives a precise, clean cut. Additionally, the deck is made from durable materials that are resistant to wear and tear, ensuring a long lifespan for the mower.

Comfort is a significant consideration in the design of the 2348 LS. The ergonomic steering wheel and high back seat provide a comfortable riding experience, allowing the user to mow for extended periods without discomfort. Furthermore, the easy-access controls are strategically placed for convenience, making the operation simple and intuitive.

For added safety, the Husqvarna 2348 LS features safety switches that automatically shut off the engine when the operator leaves the seat, preventing accidental starts. The integrated headlights also enhance visibility, allowing users to mow during dawn or dusk.

In summary, the Husqvarna 2348 LS offers a combination of power, efficiency, and comfort, making it an ideal choice for homeowners seeking a reliable riding mower. With its robust engine, versatile cutting capabilities, and user-friendly features, it ensures a well-manicured lawn with minimal effort, cementing its place as a preferred choice among garden enthusiasts.
Top Page Image Contents