Husqvarna 2348 LS manual Tractor, Brake Operation, Tires, Blade Care, Blade Removal See Fig

Page 15

MAINTENANCE

TRACTOR

Always observe safety rules when performing any main- tenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced. (See “TO CHECK BRAKE” in the Service and Adjustments section of this manual).

TIRES

•Maintain proper air pressure in all tires (See PSI on tires).

•Keep tires free of gasoline, oil, or insect control chemi- cals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OP- ERATION SYSTEM (ROS)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never operate unless the operator is in the seat.

ROS "ON" Position

Engine "ON" Position

(Normal Operating)

 

02828

CHECK REVERSE OPERATION (ROS) SYSTEM

•When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch en- gaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

BLADE CARE

For best results mower blades must be sharp. Replace worn, bent or damaged blades.

CAUTION: Use only a replacement blade approved by the manufacturer of your tractor. Using a blade not approved by the manufacturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 12)

•Raise mower to highest position to allow access to blades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

•Remove blade bolt by turning counterclockwise.

•Install new blade with stamped "GRASS SIDE" facing the ground.

IMPORTANT: To ensure proper assembly, center hole in blade must align with star on mandrel assembly.

•Install and tighten blade bolt securely (45-55 Ft. Lbs. torque).

IMPORTANT: Special blade bolt is heat treated.

 

CENTER HOLE

5/8" BOLT

BLADE

OR PIN

FIG. 12

DECK WASHOUT PORT (See Fig. 13)

Your tractor’s deck is equipped with a washout port on its surface as part of its deck wash system. It should be utilized after each use.

1.Drive the tractor to a level, clear spot on your lawn, near enough to a water spigot for your garden hose to reach.

IMPORTANT: Make certain the tractor’s discharge chute is directed AWAY from your house, garage, parked cars, etc. Remove bagger chute or mulch cover if attached.

2.Make sure the PTO (Blade Engage) is not engaged, set the parking brake, and stop the engine.

3.Thread the nozzle adapter (packaged with your tractor’s Operator’s Manual) onto the end of your garden hose.

4.Pull back the lock collar of the nozzle adapter and push the adapter onto the deck washout port at the left end of the mower deck. Release the lock collar to lock the adapter on the nozzle.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents 2348 LS General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationService III. ChildrenIV. Towing Table of Contents Unpack Carton AssemblyUnassembled Parts To Remove Tractor from CartonCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor To USE Throttle Control D See HOW to USE Your TractorTo SET Parking BRAKESee a Stopping See bTo Move Forward and Backward See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig System CharacteristicsTo Operate on Hills Using the Reverse Operation SystemTo Operate Mower See Fig Reverse Operation System ROSADD Gasoline Service REMINDER/HOUR MeterBefore Starting the Engine Check Engine OIL LevelPurge Transmission Mowing TipsLubrication Chart MaintenanceBlade Care TractorBrake Operation TiresEngine Cleaning Service and Adjustments To Install Mower See FigsTo Remove Mower See Fig First Install ANTI-SWAY BAR S Engage belt tension rod K on locking bracket L To Level Mower Mower Drive Belt Installation To Replace Mower Blade Drive BeltMower Drive Belt Removal Belt Installation To Replace Motion Drive Belt See FigBelt Removal To Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigTo Check Brake Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Points Engine dies when SCH12 SchematicElectrical KEY Part Description Chassis Tractor - Model Number 2348LS 96043004400, Product no 43 197 196 Drive532 40 53-84 Transaxle, Tufftorq K46 171 872 11 Spark Arrester KIT Engine211 6962 8179 Engine Power Rating Information Steering Assembly 532 41 Wheel, Steering 532 19 532 40 Seat Seat AssemblyWheels and Tires DecalsMower Deck 532 41 87-00 Deck Weldment Mower Mower Lift Warranty Statement Suggested Guide for Sighting Slopes for Safe Operation Service Notes Service Notes 532 41 84-82 12.01.07 TH

2348 LS specifications

The Husqvarna 2348 LS is a powerful and versatile riding lawn mower designed to meet the needs of homeowners looking for a reliable machine for their lawn care routine. Known for its robust features and ease of use, it combines functionality and comfort, making it an excellent choice for residential use.

One of the standout features of the Husqvarna 2348 LS is its powerful 24 HP Briggs & Stratton engine, which provides the necessary power to tackle tough mowing tasks efficiently. This engine is designed for optimal performance and reliability, ensuring that users can mow their lawns with confidence. The automatic transmission allows for smooth acceleration and gear shifting without the need for manual intervention, making it user-friendly for individuals of all skill levels.

The cutting deck is another critical element of the 2348 LS model. With a 48-inch cutting width, it provides an impressive mowing area that reduces the time spent mowing. The cutting height can be easily adjusted, enabling users to customize the height according to their lawn's needs. This flexibility ensures that the grass is cut evenly and maintains a healthy appearance.

The Husqvarna 2348 LS is equipped with advanced features, such as the clearcut deck design, which enhances the mowing efficiency and gives a precise, clean cut. Additionally, the deck is made from durable materials that are resistant to wear and tear, ensuring a long lifespan for the mower.

Comfort is a significant consideration in the design of the 2348 LS. The ergonomic steering wheel and high back seat provide a comfortable riding experience, allowing the user to mow for extended periods without discomfort. Furthermore, the easy-access controls are strategically placed for convenience, making the operation simple and intuitive.

For added safety, the Husqvarna 2348 LS features safety switches that automatically shut off the engine when the operator leaves the seat, preventing accidental starts. The integrated headlights also enhance visibility, allowing users to mow during dawn or dusk.

In summary, the Husqvarna 2348 LS offers a combination of power, efficiency, and comfort, making it an ideal choice for homeowners seeking a reliable riding mower. With its robust engine, versatile cutting capabilities, and user-friendly features, it ensures a well-manicured lawn with minimal effort, cementing its place as a preferred choice among garden enthusiasts.
Top Page Image Contents