ASSEMBLY
3INSTALL HOOD INLET
1.Place the cover assembly upside down on a flat surface.
2.Place the inlet in the cover and direct it out of the large hole on the front side of the cover. Set the inlet so that the opening will be facing into the containers and the inlet hood is upwards.
3.To attach inlet, place one washer on each of the six bolts (¼ x ¾). Place the bolt and washer through the inlet hole.
4.Secure on outside of hood with another flat washer and a nyloc nut.
Inside Cover
Inlet with opening downwards
4MOUNTING COVER ASSEMBLY TO SUPPORT ASSEMBLY
For ease of assembly, you may wish assistance from another person for mounting the cover assembly to mower.
1.Position cover assembly on the ground behind the mower.
2.Lift and rotate cover to align the frame bracket with the hanger and slide the cover down until secure.
Cover Assembly
Frame
Bracket
Hanger
Outside Cover
9